ASTM A1025/A1025M-10(2020) PDF

ASTM A1025/A1025M-10(2020) PDF

Standard Specification for Ferroalloys and Other Alloying Materials, General Requirements

$32.00 $64.00 -50%
Product Code: ASTM A1025/A1025M
Stock In Stock
Published: 2020
Number of Pages: 4

Available Options

Product Description

This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials. The chemical analysis method shall be agreed upon by the purchaser and supplier. Unless otherwise specified, the material shall be sampled for determination of chemical composition and size.
 Scope
 1.1  This specification covers a group of common requirements that, unless otherwise specified in an individual specification, shall apply to ferroalloys and other alloying materials under each of the following ASTM specifications:
 Title of Specification
 ASTM Designation
 Ferromanganese
 A99
 Ferrosilicon
 A100
 Ferrochromium
 A101
 Ferrovanadium
 A102
 Ferromolybdenum
 A132
 Molybdenum Oxide Products
 A146
 Ferroboron
 A323
 Ferrotitanium
 A324
 Chromium Metal
 A481
 Ferrochrome-Silicon
 A482/A482M
 Silicomanganese
 A483/A483M
 Calcium-Silicon Alloys
 A495
 Ferrocolumbium
 A550
 Electrolytic Manganese Metal
 A601/A601M
 Nickel Oxide Sinter
 A636
 Ferromanganese Silicon
 A701/A701M
 Titanium Scrap for Use in Deoxidation and Alloying of Steel
 A845
 Aluminum Scrap for Use in Deoxidation and Alloying of Steel
 A846
 Silicon Metal
 A922
 1.2  This specification also covers a group of supplementary requirements which may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
 1.3  In case of conflict between the requirements of the individual specification and this general specification, the former shall prevail.
 1.4   Units— The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
 1.4.1  This specification is expressed in both inch-pound units and in SI units (within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply.
 1.5   This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
 1.6   This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ASTM A1025/A1025M-10(2020) PDF

ASTM A1025/A1025M-10(2020) PDF

$32.00 $64.00