Railway signalling symbols-Specification for symbols for circuit diagrams
Publishing information: This part of BS 376 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 April 2015. It was prepared by Technical Committee GEL/9/1, Signalling and communications, under the Technical Committee GEL/9, Railway electrotechnical applications. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This part of BS 376 supersedes BS 376-2:1954 Railway Signalling Symbols – Part 2: Wiring symbols and written circuits, which is withdrawn. Relationship with other publications BS 376, Railway signalling symbols – Part 1: Specification for schematic symbols Part 1 shows schematic symbols designed for use on railway layout plans to show the signalling requirements. BS 376, Railway signalling symbols – Part 2: Symbols for circuit diagrams – Specification Part 2 (this part) shows the actual apparatus used, with its electrical connections and simplified wiring diagrams.
Information about this document: This is a full revision of the standard, updated to current practice. This standard has its origins in a specification published by the Railway Signal Association in the USA in 1911, by which date a scheme of symbols and nomenclature for electrically operated apparatus had evolved, using both written circuits and wiring symbols. Subsequent issues of the standard have sought to be backward-compatible with the original scheme, since signalling documentation is maintained for the whole life of the signalling. A standard system of nomenclature and labelling of wires is specified. Typical applications are illustrated in Annex A. If a symbol required for railway signalling purposes does not appear in this standard, the symbol should be taken from an appropriate British Standard or International Standard.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with The BSI guide to standardization – Section 2: Rules for the structure, drafting and presentation of British Standards, subclause 11.3.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard. This part of BS 376-2 shows railway signalling symbols for written circuits and the traditional wiring symbols in tables side by side. When necessary, to avoid confusion, diagrams may be marked with the following reference: Symbols to BS 376-2:2015
Scope: This British Standard specifies the symbols to be used on railway signalling circuit diagrams but does not provide guidance on their application. It also gives a standard system of nomenclature and labelling of wires such that each wire can be readily identified with that shown on the circuit diagram. This British Standard does not cover symbols for high voltage power distribution, telecommunications or electronic products. These are covered in IEC 60617 or an appropriate British Standard. This British Standard does not include proprietary systems and specialized applications. NOTE 1 The symbols in this British Standard provide for apparatus in general use. Wiring symbols have been designed so that they can be combined together where one does not represent the complete device. In this British Standard, where certain elements are added for illustrative purposes, they are shown by dashed lines. If additional information is required to support the symbol, a “#” may be used to reference a note on the diagram. NOTE 2 The size of symbols as drawn are in proportion but are not necessarily relative to one another; nor do they give the specific size to be used. The relative thickness of lines may also be varied, e.g. for contact elements.
Contents:
- Scope
- Annexes
- Annex A (informative) Examples of written circuits and wiring symbols
- Annex B (informative) Labelling wires
- Bibliography