Intruder and hold-up alarm systems. Commissioning, maintenance and remote support. Code of practice
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2016. It was prepared by Subcommittee GW/1/2, Installed alarm systems, under the authority of Technical Committee GW/1, Electronic security systems. A list of organizations represented on these committees can be obtained on request to their secretary.
Use of this document: As a code of practice, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations. Relationship with other publications This British Standard incorporates maintenance recommendations formerly included in BS 4737, Intruder alarm systems in buildings, and is intended to be used in conjunction with PD 6662, Scheme for the application of European Standards for intrusion and hold-up alarm systems to provide detail necessary for the implementation of the relevant provisions of DD CLC/TS 50131-7. As a result of the publication of the BS EN 50131 series, BS 4737-1, BS 4737-2, BS 6799, BS 7042 were withdrawn, but suppliers might wish to continue maintaining intruder alarm systems which conform to these withdrawn standards.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard gives recommendations for the commissioning, on-site corrective and preventative maintenance, remote system checks and remote support of an I&HAS. This British Standard is applicable to all I&HASs under maintenance, including those installed in accordance with BS EN 50131 (all parts) (see Foreword) and PD 6662.
Contents:
- Foreword
- Introduction
- Scope
- Annexes
- Annex A (normative) Commissioning of an I&HAS
- Annex B (normative) Preventative maintenance checks
- Annex C (informative) Calculation of standby battery capacity
- Bibliography