BS +AU 148-15-1969 PDF

BS +AU 148-15-1969 PDF

Methods of test for motor vehicle paints-Resistance to chipping

$90.17 $180.34 -50%
Publisher
isbn 058005358X
Product Code: BS +AU 148-15
Stock In Stock
Published: 03/31/1969
Number of Pages: 8
File Size: 1 file, 810 KB

Available Options

Product Description

Methods of test for motor vehicle paints-Resistance to chipping

Scope: This Part of this British Standard describes a method to provide information regarding the resistance of a paint system to chipping by the impact of gravel and grit thrown up from road surfaces. 2 Preparation of tests panels 2.1 Panels, 150 mm × 100 mm or other convenient size, specified and pretreated in accordance with the requirements of BS 3900-A32) (note particularly Clause 2.2) shall be treated, in accordance with the requirements of BS 3900-A42) with the paint system to be tested. Normally steel panels are used, but it may be appropriate to use other substrates. 2.2 Panels shall be aged, under normal laboratory conditions, for 7 days. 3 Equipment 3.1 The equipment required is as follows: 1) A straight pipe 4.5 m long and 50 mm internal diameter, supported vertically and fitted with a slide across the pipe 50 mm from the top. 2) A panel support to hold the test panel at an angle of 45° immediately below the lower end of the pipe. The distance from the centre of the lower end of the pipe to the centre of the panel is 100 mm. Provision is made for the longer sides of the test panel to be firmly attached to the support rails of 25 mm wide angle iron. 3) A suitable shield, around the panel support, to prevent scattering of the nuts used in the test and to facilitate their subsequent collection in a container. 4) 100 ! in hexagon nuts, grade 3, to BS 17683). NOTE Experience has shown that the use of nuts does simulate the results obtained in service and, at the same time, provides a more readily defined missile than gravel. 4 Test method 4.1 The panel shall be secured to the support with the painted surface uppermost. The nuts shall be tipped into the tube above the slide, which is then withdrawn sharply. The panel shall then be examined for damage. 4.2 Unless otherwise agreed the test shall be carried out at room temperature. NOTE After each 100 tests, the nuts shall be replaced by a new set. 5 Assessment 5.1 The degree of chipping shall be assessed visually by co

Contents:

  • Foreword
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS +AU 148-15-1969 PDF

BS +AU 148-15-1969 PDF

$90.17 $180.34