BS PD CEN/TR 17079-2018 PDF

BS PD CEN/TR 17079-2018 PDF

Design of fastenings for use in concrete. Redundant non-structural systems

$90.17 $180.34 -50%
Publisher
isbn 9780580916687
Product Code: BS PD CEN/TR 17079
Stock In Stock
Published: 10/05/2018
Number of Pages: 12
File Size: 1 file, 500 KB

Available Options

Product Description

Design of fastenings for use in concrete. Redundant non-structural systems

Scope: 1.1 General This Technical Report provides design rules for fasteners used to connect statically indeterminate non- structural light weight systems (e.g. suspended ceilings, pipe work, ducting) to concrete members such as walls or floors (see Figure 1)). The proposed design model may be applied to post-installed mechanical and bonded anchors covered by EN 1992‑4:2017, 1.2. Their suitability is given in a European Technical Product Specification. The design rules assume the following: — under extreme conditions (e.g. large crack width) excessive slip or failure of a fastener might occur; — elements or systems are attached with at least three fixing points with one or more fasteners at each fixing point; — where more than one fastener is used at a fixing point (MF, see Figure 1), only fasteners of the same type, size and length are used; — the attached system is sufficiently stiff to transfer the load at any fixing point to adjacent fixing points without significantly impairing the performance characteristics of the system both at serviceability and ultimate limit states. Key SF one fastener per fixing point MF two or more fasteners per fixing point Figure 1 — Statically indeterminate non-structural systems with one or more fasteners per fixing point — Examples This Technical Report applies to non-structural applications in structures covered by EN 1992‑1‑1. In applications where special considerations apply, e.g. nuclear power plants or civil defence structures, modifications may be necessary. This document does not cover the design of the fixture. The design of the fixture will be carried out to comply with the appropriate Standards. 1.2 Type of fasteners Post-installed fasteners according to EN 1992‑4. 1.3 Fastener dimensions and materials EN 1992‑4:2018, 1.3 applies with the following addition: In precast pre-stressed hollow core elements the minimum embedment depth may be reduced to a value to ensure proper functioning if placed in a flange (wall) of minimum thic

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD CEN/TR 17079-2018 PDF

BS PD CEN/TR 17079-2018 PDF

$90.17 $180.34