ISO 19927-2018 PDF

ISO 19927-2018 PDF

Fibre-reinforced plastic composites - Determination of interlaminar strength and modulus by double beam shear test

$96.50 $193.00 -50%
Product Code: ISO 19927
Stock In Stock
Edition: 1ST
Published: 08/2018
Number of Pages: 28
File Size: 1 file, 2 Bytes

Available Options

Product Description

Fibre-reinforced plastic composites - Determination of interlaminar strength and modulus by double beam shear test

Introduction: Interlaminar shear (ILS) properties of load-bearing composite laminates are important for structural design, stress analysis and numerical modelling, material development and selection, component manufacture as well as for repair of delaminated structural components. A number of test methods have been developed for the determination of shear properties of composite laminates and several have been standardized, including short beam strength (SBS) [ASTM D2344, ISO 14130, EN 23771) and EN 25631)], V-notched beam (known also as Iosipescu shear), ASTM D5379, V-notched rail (ASTM D7078) and notched tension (ASTM D3846, BS 4994) or notched compression (BS 6464). SBS methods are very popular due to their simplicity in specimen preparation, test operation and cost-effectiveness, though they are used to determine only an apparent ILS strength for QA purposes rather than for use in design. However, a loaded SBS specimen does not have a pure ILS region within its gauge section so it often fails in a number of modes, dependent on, amongst others, type of composite materials, lay-up and specimen thickness. Unacceptable SBS failure modes include flexural failure, local crushing (under central loading roller) and plastic deformation and roller-induced through-thickness shear band. The DBS method is based on loading a composite beam on double support spans (i.e. between 5 loading points), which generates a stress state that minimises axial bending stresses while promoting interlaminar shear s

Scope: This document specifies a procedure for determining the interlaminar strength, and modulus, by double beam shear (DBS) tests of fibre-reinforced plastic composites. The method is suitable for use with glass or carbon fibre-reinforced plastic composites with thermoset matrices, providing an acceptable interlaminar failure is obtained. This document only applies to laminate with a symmetrical and balanced lay‐up as it avoids bending/ twisting or bending/extension coupling deformations (see 6.2). The preferred lay-up is unidirectional, with fibres aligned along the specimen (axial) length. The suitability of the test for specific lay-ups, matrices and fibres (e.g. natural) are assessed by trial tests to ensure the correct delamination failures are obtained.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19927-2018 PDF

ISO 19927-2018 PDF

$96.50 $193.00