ISO 20029-1-2017 PDF

ISO 20029-1-2017 PDF

Plastics - Thermoplastic polyester/ ester and polyether/ester elastomers for moulding and extrusion - Part 1: Designation system and basis for specification

$48.00 $96.00 -50%
Product Code: ISO 20029-1
Stock In Stock
Edition: 1ST
Published: 11/2017
Number of Pages: 18
File Size: 1 file, 452 Bytes

Available Options

Product Description

Plastics - Thermoplastic polyester/ ester and polyether/ester elastomers for moulding and extrusion - Part 1: Designation system and basis for specification

Introduction: ISO 14910-1:2013 is complex and does not fit with daily practice anymore. In practice, ISO 18064 and ISO 11469 are, in combination, “improperly” being used as a designation system for, e.g. marking. The aim of this document is to simplify the data block system and to connect more to ISO 18064 and ISO 11469, where the first two blocks are used for generic identification and marking of products. © ISO 2017 – All rights reserved

Scope: This document establishes a system of designation for thermoplastic polyester/ester and polyether/ester elastomers, which may be used as the basis for specifications. The types of thermoplastic polyester/ester and polyether/ester elastomer are differentiated from each other by a classification system based on appropriate levels of the designatory properties: a) hardness; b) melting temperature; c) tensile/flexural modulus of elasticity; and on information about the intended application and/or method of processing, important properties, additives, colour, fillers and reinforcing materials. This document is applicable to all thermoplastic polyester/ester and polyether/ester elastomers. It applies to materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colourants, fillers or other additives. It is not intended to imply that materials having the same designation give necessarily the same performance. This document does not provide engineering data, performance data or data on processing conditions which may be required to specify a material. If such additional properties are required, they are intended to be determined in accordance with the test methods specified in ISO 20029-2, if suitable. In order to designate a thermoplastic polyester/ester or polyether/ester elastomer to meet particular specifications, the requirements are given in data block 5 (see 4.1).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20029-1-2017 PDF

ISO 20029-1-2017 PDF

$48.00 $96.00