IEC 60079-33-2012 PDF

IEC 60079-33-2012 PDF

Explosive atmospheres-Part 33: Equipment protection by special protection “s”

$163.93 $327.86 -50%
Product Code: IEC 60079-33
Stock In Stock
Edition: 1.0
Published: 09/2012
Number of Pages: 84
File Size: 1 file, 576 Bytes

Available Options

Product Description

Explosive atmospheres – Part 33: Equipment protection by special protection “s”

Introduction: This part of IEC 60079 was created in response to a request from the IECEx certification system to provide a set of requirements to be used for certification within the IECEx product certification scheme when the standards for existing types of protection were not applicable. The present standard refers to the use of one or more independent verifiers, in accordance with ISO/IEC rules on the writing of standards that mitigate against specifying particular forms of conformity assessment. The IECEx system will specify how the term "independent verifier" will be interpreted for the purposes of the scheme. For example, it may specify that in the case of three independent verifiers they shall all be certification body members of the scheme, each accepted specifically for the purpose of assessing special protection applications and each from a separate member country of the system. The purpose of IEC 60079-33 special protection “s” for any equipment protection level (EPL) is to allow design, assessment and testing of equipment or parts of equipment that cannot be fully assessed within a recognized type of protection or combination of recognized types of protection because of functional or operational limitations and where the desired equipment protection level can be achieved by the use of this standard. Special protection “s” allows a design concept that cannot comply in full with recognized types of protection, or where the design concept is not covered by recognized types of prot

Scope: This part of IEC 60079 gives the specific methodology for the assessment and testing, and requirements for marking of electrical equipment, parts of electrical equipment and Ex components with special protection “s”. This part of IEC 60079 applies to electrical equipment employing a method of protection not covered by any existing standard in the IEC 60079 series, electrical equipment employing one or more recognized types of protection where the design and construction is not fully compliant with the standard for the type of protection, electrical equipment where the intended use is outside the parameters of the scope of the standard for the type of protection. This part of IEC 60079 is not intended for equipment that is covered by the scope of other IEC 60079 equipment standards unless it is clearly demonstrated that compliance with the type of protection is not feasible, and additional measures are applied to establish an equivalent equipment protection level. This part of IEC 60079 for special protection “s” is applicable to Group I, Group II and Group III and for equipment protection levels Ma, Mb, Ga, Gb, Gc, Da, Db and Dc, as defined in IEC 60079-0. Certain specific guidance for assessment and testing are provided in the annexes to this standard. This standard supplements and modifies the general requirements of IEC 60079-0. Where a requirement of this standard conflicts with a requirement of IEC 60079-0, the requirement of this standard shall take precedence. NOTE 1 This standard may be used where equipment requires a higher EPL than the underlying protection techniques provide. Additional control measures or additional design and test requirements would be applied. NOTE 2 Parts of equipment that can be designed and tested to standardized techniques should be so designed. Only those parts where conformance with essential safety requirements is achieved through alternative controls should be considered for special protection “s”. Equipment similar in attributes and performance to other equipment within a particular type of protection should be reviewed first to that method of protection prior to being considered for the use of Ex ”s”’. Some parts of IEC 6

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Application of special protection “s”

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60079-33-2012 PDF

IEC 60079-33-2012 PDF

$163.93 $327.86