Electrical installations in ships – Part 507: Small vessels
Introduction: This International Standard incorporates and coordinates, as far as possible, the existing requirements for electrical installations relevant to small vessels as published in other parts of the IEC 60092 series and the IEC 60364 series.
Scope: 1.1 General This part of IEC 60092 specifies requirements for the design, construction and installation of electrical systems in small vessels, which have a length of up to 50 m, or which have a gross tonnage not exceeding 500 Gross Tonnes (GT), designed for use on inland waters or at sea. It is not intended to apply to: a) small craft equipped only with a battery supplying circuits for engine starting and navigation lighting recharged from an inboard or outboard engine driven alternator. b) recreational craft of less than 24 m hull length requiring to conform to the Recreational Craft Directive 94/25/EC Annex 1 Essential Requirements Part 5.3 Electrical systems, except for three-phase alternating current installations in such recreational craft which operate at a nominal voltage not exceeding AC 500 V. 1.2 Electrical systems This standard applies to the types of DC and AC electrical systems described below, individually or in combination. a) Direct current system which operates at a nominal voltage not exceeding DC 50 V. For many small vessels, this will be the main electrical system supported by batteries for engine starting, navigation lights, navigational aids and communications equipment, lighting and other DC power consumer or converter equipment. b) Single-phase alternating current system which operates at a nominal voltage not exceeding AC 250 V. Such a system may be the principal electrical power system of a vessel or a system which may only be energized when connected to a shore supply. AC extra-low voltage, safety extra-low voltage, and other circuits may also comprise part of a single-phase AC system. A vessel may also be equipped with DC system(s) for equipment supplied from batteries as in 1.2 a) above. c) Three-phase alternating current system which operates at a nominal voltage not exceeding AC 500 V. The three-phase system is likely to be the principal electrical power system of a vessel’s electrical installation. Such a vessel may also be equipped with single-phase AC circuits(s) similar to 1.2 b) above and DC system(s) for equipment supplied from batteries as in 1.2 a) above. NOTE 1 Concerning recreational craft of less than 24 m hull length r
Contents:
- FOREWORD
- INTRODUCTION
- Scope