Safety of machinery - Electrical equipment of machines - Part 11: Requirements for equipment for voltages above 1 000 V AC or 1 500 V DC and not exceeding 36 kV
Introduction: This part of IEC 60204 provides requirements and recommendations relating to the high- voltage electrical equipment (HV equipment) of machines together with its associated low- voltage electrical equipment (LV equipment) so as to promote safety of persons and property, consistency of control response, maintainability. Figure 1 is a block diagram of a machine and associated equipment showing the various elements of the electrical equipment addressed in this document. Numbers in parentheses (…) refer to clauses and subclauses in this document. It is understood that all of the elements taken together including the safeguards, software and the documentation constitute the machine or group of machines working together with usually at least one level of supervisory control. This document should be used in conjunction with IEC 602041. HV equipment can include LV control parts in the same general enclosure or in separate compartments.
Scope: This part of IEC 60204 applies to electrical and electronic equipment and systems to machines, including a group of machines working together in a co-ordinated manner, which operate at nominal voltages above 1 000 V AC or 1 500 V DC and not exceeding 36 kV AC or DC with nominal frequencies not exceeding 60 Hz. In this document, the term HV equipment also covers the LV equipment forming an integral part of the equipment operating at high voltage. The requirements in this document primarily cover the parts operating at high-voltage except where explicitly stated otherwise. NOTE 1 LV equipment not forming part of the HV equipment is covered by IEC 60204-1:2016. NOTE 2 In this document, the term "electrical" includes both electrical and electronic matters (i.e. electrical equipment means both the electrical and the electronic equipment). NOTE 3 This document does not apply to independent high-voltage power supply installations for which separate IEC standards exist. The electrical equipment covered by this document commences at the point of connection of the supply to the electrical equipment of the machine (see 5.1). NOTE 4 For the requirements for high-voltage power supply installations, see IEC 61936-1. This document is a generic safety standard. It does not cover all the requirements (e.g. guarding, interlocking or control) which are needed or required by other standards or regulations in order to safeguard personnel from hazards other than electrical hazards. Each type of machine has unique requirements to be accommodated to provide adequate safety. NOTE 5 In some machines the high-voltage power supply can be produced by a step-up transformer (autotransformer), supplied by a low-voltage system (e.g. by a LV generator). NOTE 6 In the context of this document, the term "person" refers to any individual; "personnel" are those persons who are assigned and instructed by the user or his agent(s) in the use and care of the machine in question. This part of IEC 60204 specifically includes, but is not limited to, machines as defined in 3.29 (Annex A lists examples of machines whose electrical equipment can be covered by this document). For protection against electric sh
Contents:
- FOREWORD
- INTRODUCTION
- Scope