Low-voltage electrical installations – Part 7-709: Requirements for special installations or locations – Marinas and similar locations
Introduction: The requirements of this part of IEC 60364 supplement, modify or replace certain of the general requirements contained in Parts 1 to 6 of IEC 60364. The clause numbering appearing after 709 refers to the corresponding parts or clauses of IEC 60364, Parts 1 to 6. Numbering of clauses does not, therefore, necessarily follow sequentially. Numbering of figures and tables takes the number of this part followed by a sequential number. The absence of reference to a part or a clause means that the general requirements contained in Parts 1 to 6 of IEC 60364 are applicable.
Scope: The particular requirements specified in this part of IEC 60364 apply only to circuits intended to supply pleasure craft or houseboats in marinas and similar locations. NOTE 1 In this part “marina” means “marina and similar locations”. The particular requirements do not apply to the supply of house boats if they are directly supplied from the public network. The particular requirements do not apply to the internal electrical installations of pleasure craft or house boats. NOTE 2 For electrical installations of pleasure craft, see IEC 60092-507. NOTE 3 The electrical installations of house boats should comply with the general requirements of IEC 60364, together with the relevant particular requirements of IEC 60364-7. For the remainder of the electrical installation of marinas and similar locations the general requirements of IEC 60364 together with the relevant particular requirements of IEC 60364-7 apply. 709.2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60038, IEC standard voltages IEC 60309-1, Plugs, socket-outlets and couplers for industrial purposes – Part 1: General requirements IEC 60309-2, Plugs, socket-outlets and couplers for industrial Purposes – Part 2: Dimensional interchangeability requirements for pin and contact-tubes accessories IEC 60364-4-43, Electrical installations of buildings – Part 4-43: Protection for safety – Protection against overcurrent IEC 61558-2-4, Safety of power transformers, power supply units and similar – Part 2: Particular requirements for isolating transformers for general use IEC 62262, Degrees of protection provided by enclosures for electrical equipment against external mechanical impacts (IK code) 709.3 Terms and definitions For the purposes of this document, the following terms and definitions apply. – 18 – 60364-7-709 CEI:2007 +A1:2012 AVANT-PROPOS .................................................................................................................. 19 INTRODUCTION ...........
Contents:
- FOREWORD
- INTRODUCTION
- 709 Marinas and similar locations
- Scope