IEC 60393-1-2008 PDF

IEC 60393-1-2008 PDF

Potentiometers for use in electronic equipment-Part 1: Generic specification

$255.36 $510.71 -50%
Product Code: IEC 60393-1
Stock In Stock
Edition: 3.0
Published: 05/2008
Number of Pages: 108
File Size: 1 file

Available Options

Product Description

Potentiometers for use in electronic equipment – Part 1: Generic specification

Scope: This part of IEC 60393 is applicable to all types of resistive potentiometers, including lead- screw actuated types, presets, multi-turn units, etc. to be used in electronic equipment. It establishes standard terms, inspection procedures and methods of test for use in sectional and detail specifications of electronic components for quality assessment or any other purpose. It has been mainly written, and the test methods described, to conform to the widely used single-turn rotary potentiometer with an operating shaft. For other types of potentiometers: the angle of rotation may be several turns; the reference to an operating shaft shall apply to any other actuating device; the angular rotation shall be taken to mean mechanical travel of the actuating device; a value for force shall be prescribed instead of a value for torque if the actuating device moves in a linear instead of a rotary manner. These alternative prescriptions will be found in the sectional or detail specification. When a component is constructed as a variable resistor, i.e. as a two-terminal device, the detail specification shall prescribe the modifications required in the standard tests. 1.2

Contents:

  • FOREWORD
  • Scope
  • 4.10 Matching of the resistance law (for ganged potentiometers only)
  • 4.11 Switch contact resistance (when appropriate)
  • 4.12 Voltage proof (insulated styles only)
  • 4.13 Insulation resistance (insulated styles only)
  • 4.14 Variation of resistance with temperature
  • 4.15 Rotational noise
  • 4.16 Contact resistance at low-voltage levels
  • 4.17 Setting ability (adjustability) and setting stability
  • 4.18 Starting torque
  • 4.19 Switch torque
  • 4.20 End stop torque
  • 4.21 Locking torque
  • 4.22 Thrust and pull on shaft
  • 4.23 Shaft run-out
  • 4.24 Lateral run-out
  • 4.25 Pilot (or spigot) diameter run-out
  • 4.26 Shaft end play
  • 4.27 Backlash
  • 4.28 Dither
  • 4.29 Output smoothness
  • 4.30 Robustness of terminals
  • 4.31 Sealing
  • 4.32 Solderability
  • 4.33 Resistance to soldering heat
  • 4.34 Change of temperature

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60393-1-2008 PDF

IEC 60393-1-2008 PDF

$255.36 $510.71