IEC 60519-6-2022 PDF

IEC 60519-6-2022 PDF

Safety in installations for electroheating and electromagnetic processing-Part 6: Particular requirements for high frequency dielectric and microwave heating and processing equipment

$239.59 $479.18 -50%
Product Code: IEC 60519-6
Stock In Stock
Edition: 4.0
Published: 01/2022
Number of Pages: 142
File Size: 1 file, 4 Bytes

Available Options

Product Description

Safety in installations for electroheating and electromagnetic processing – Part 6: Particular requirements for high frequency dielectric and microwave heating and processing equipment

Introduction: Some types of electroheating equipment, including the workload, can emit hazardous levels of infrared radiation. It has been agreed in the IEC Technical Committee 27 that IEC 60519-12 addresses these infrared radiation aspects for this document. This document presumes that the manufacturer possesses sufficient knowledge in equipment design, manufacturing and documentation in accordance with good engineering practise, and that the installation or equipment is operated and maintained only by personnel consisting of skilled or instructed persons. This document is intended to verify whether the installation or equipment meets the requirements of safety, by design, and numerical verification if carefully carried out, site acceptance tests, routine tests or inspection.

Scope: This clause of Part 1 is modified by the following regarding the areas of application. Modification: This part of IEC 60519 is applicable to equipment using high frequency or microwave energy alone or in combination with other kinds of energy for industrial heating and processing of materials. It is also applicable to HF and MW generators made available to users as separate units. This part is applicable to equipment operating in the frequency range 3 MHz to 300 GHz, with the following limitations. This document applies to only high frequency dielectric heating and processing as defined in 3.1.103. It does not apply to induction heating, which it is possible to carry out in the lower part of the specified frequency band and is covered by IEC 60519-3, with magnetic field safety aspects addressed in IEC TS 62997:2017, the latter to be replaced by a technical report (TR) or by a revised technical specification (TS). The ISM centre frequencies for dielectric heating and processing of industrial interest are narrow bands about 6,78 MHz, 13,56 MHz, 27,12 MHz and 40,68 MHz. Different field emission measurement procedures and limiting values are applicable, depending on the processing frequency in the high frequency range 3 to 300 MHz. Specifications are in Annex BB. This document specifies limits for microwave emission only for the ISM frequencies between 800 MHz and 6 MHz, as specified in Annex CC. For other microwave frequencies the basic restriction and IEC 62311 apply. The foundations for compliance with emission values are the basic restrictions, referred to in the IEEE/ANSI C95.1:2019 and Directive 2013/35/EU. However, maximum HF processing frequency electric and magnetic field values are taken from the IEEE/ANSI C95.1:2019 standard, as indicated in Annex BB. This document is not applicable to: appliances for household and similar use (covered by e.g. IEC 60335-2-25); commercial use (covered by IEC 60335-2-90 and IEC 60335-2-110); laboratory use (covered by IEC 61010-2-010); medical high frequency equipment and accessories (covered by IEC 60601-2-2). NOTE 101 Since high frequency and microwave tunnel ovens and also some other types of microwave and high frequency

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60519-6-2022 PDF

IEC 60519-6-2022 PDF

$239.59 $479.18