IEC 60664-3 (REDLINE + STANDARD)-2016 PDF

IEC 60664-3 (REDLINE + STANDARD)-2016 PDF

Insulation coordination for equipment within low-voltage systems-Part 3: Use of coating, potting or moulding for protection against pollution

$171.50 $342.99 -50%
Product Code: IEC 60664-3 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 11/2016
Number of Pages: 80
File Size: 1 file, 1.9 MB

Available Options

Product Description

Insulation coordination for equipment within low-voltage systems – Part 3: Use of coating, potting or moulding for protection against pollution

Introduction: This part of IEC 60664 details the conditions in which the reduction of clearance and creepage distances can apply to rigid assemblies such as printed boards or terminals of components. Protection against pollution can be achieved by any kind of encapsulation such as coating, potting or moulding. The protection may be applied to one or both sides of the assembly. This standard specifies the insulating properties of the protecting material. Between any two unprotected conductive parts, the clearance and creepage distance requirements of IEC 60664-1 or IEC 60664-5 apply. This document refers only to permanent protection. It does not cover assemblies after repair. Technical committees need to should consider the influence on the protection of overheated overheating conductors and components, especially under fault conditions, and to decide if any additional requirements are necessary. Safe performance of assemblies is dependent upon a precise and controlled manufacturing process for the application of the protective system. Requirements for quality control, e.g. by sampling tests, should be considered by technical committees.

Scope: This part of IEC 60664 applies to assemblies protected against pollution by the use of coating, potting or moulding, thus allowing a reduction of clearance and creepage distances as described in Part 1 or Part 5 IEC 60664-1. NOTE 1 When reference is made to Part 1 or Part 5, IEC 60664-1 or IEC 60664-5 are meant. This document describes the requirements and test procedures for two methods of protection: type 1 protection improves the microenvironment of the parts under the protection; type 2 protection is considered to be similar to solid insulation. This document also applies to all kinds of protected printed boards, including the surface of inner layers of multi-layer boards, substrates and similarly protected assemblies. In the case of multi-layer printed boards, the distances through an inner layer are covered by the requirements for solid insulation in Part 1 IEC 60664-1. NOTE 2 Examples of substrates are hybrid integrated circuits and thick-film technology. This document refers only to permanent protection. It does not cover assemblies that are subjected to mechanical adjustment or repair. The principles of this standard are applicable to functional, basic, supplementary and reinforced insulation.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60664-3 (REDLINE + STANDARD)-2016 PDF

IEC 60664-3 (REDLINE + STANDARD)-2016 PDF

$171.50 $342.99