Flexible insulating sleeving – Part 3: Specifications for individual types of sleeving – Sheets 116 and 117: Extruded polychloroprene, general purpose
Introduction: This document is one of a series of standards which deals with flexible insulating sleeving for electrical purposes. The series consists of three parts: Part 1: Definitions and general requirements (IEC 60684-1); Part 2: Methods of test (IEC 60684-2); Part 3: Specification requirements for individual types of sleeving (IEC 60684-3). This document comprises two of the sheets of Part 3, as follows: Sheet 116: Extruded polychloroprene, general purpose: thin wall; Sheet 117: Extruded polychloroprene, general purpose: thick wall.
Scope: This part of IEC 60684 gives the requirements for non-heat-shrinkable sleeving, extruded from compounds based on polychloroprene elastomer. This sleeving has been found suitable for temperatures up to 95 °C. Sleeving of this type is normally available with internal diameters up to 25 mm, and in the following opaque colours: black, brown, red, orange, yellow, green, blue, violet, grey, white and pink. Sizes or colours other than those specifically listed in this document may can possibly be available as custom items. These items shall be are considered to comply with this document if they comply with the other property requirements listed in Table 2. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should will be based on the actual requirements necessary for adequate performance in the application and not based on the specification alone.
Contents:
- FOREWORD
- INTRODUCTION
- Scope