IEC 60695-11-11-2021 PDF

IEC 60695-11-11-2021 PDF

Fire hazard testing-Part 11-11: Test flames-Determination of the characteristic heat flux for ignition from a non-contacting flame source

$132.41 $264.81 -50%
Product Code: IEC 60695-11-11
Stock In Stock
Edition: 1.0
Published: 05/2021
Number of Pages: 34
File Size: 1 file, 2.5 MB

Available Options

Product Description

Fire hazard testing – Part 11-11: Test flames – Determination of the characteristic heat flux for ignition from a non-contacting flame source

Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective of component, circuit and equipment design as well as the choice of materials is to reduce, to acceptable levels, the potential risks of fire even in the event of foreseeable abnormal use, malfunction or failure. IEC 60695-1-10, IEC 60695-1-11 and IEC 60695-1-12 provide guidance on how this is to be accomplished. Fires involving electrotechnical products can be initiated from external non-electrical sources. Considerations of this nature are dealt with in an overall fire hazard assessment. The aim of the IEC 60695 series of standards is to save lives and property by reducing the number of fires or reducing the consequences of the fire. This can be accomplished by trying to prevent ignition caused by an electrically energised component part and, in the event of ignition, to confine any resulting fire within the bounds of the enclosure of the electrotechnical product. trying to minimise flame spread beyond the product’s enclosure and to minimise the harmful effects of fire effluents including heat, smoke and toxic or corrosive combustion products. This international standard is to be used to measure and describe the properties of materials used for electrotechnical products and sub-assemblies in response to heat from a non- contacting flame source or heat source under controlled laboratory conditions which is charact

Scope: This part of IEC 60695 describes a test method used to determine the characteristic heat flux for ignition (CHFI) from a non-contacting flame source for materials used in electrotechnical products, sub-assemblies or their parts. It provides a relationship between ignition time and incident heat flux. A test specimen cut from an end-product or sub-assembly can be tested by this test method. This part of IEC 60695 can be used in the fire hazard assessment and fire safety engineering procedures described in IEC 60695-1-10, IEC 60695-1-11 and IEC 60695-1-12. This basic safety publication is intended for use by technical committees in the preparation of standards in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications. The requirements, test methods or test conditions of this basic safety publication will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Precision data
  • 11 Test report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-11-11-2021 PDF

IEC 60695-11-11-2021 PDF

$132.41 $264.81