IEC 60695-2-11-2021 PDF

IEC 60695-2-11-2021 PDF

Fire hazard testing-Part 2-11: Glowing/hot-wire based test methods-Glow-wire flammability test method for end products (GWEPT)

$50.44 $100.88 -50%
Product Code: IEC 60695-2-11
Stock In Stock
Edition: 3.0
Published: 10/2021
Number of Pages: 36
File Size: 1 file, 1 Byte

Available Options

Product Description

Fire hazard testing – Part 2-11: Glowing/hot-wire based test methods – Glow-wire flammability test method for end products (GWEPT)

Introduction: In the design of any electrotechnical product, the risk of fire and the potential hazards associated with fire need to be considered. In this respect the objective within the design of component, circuit, and product design, as well as the choice of the materials, is to reduce to acceptable levels the potential risks of fire during normal operating conditions, reasonable foreseeable abnormal use, malfunction, and/or failure. IEC 60695-1-10 [1]1, together with its companion IEC 60695-1-11 [2], has been developed to provide guidance on how this is to be accomplished. The primary aims of IEC 60695-1-10 and IEC 60695-1-11 are to provide guidance on how to: a) prevent ignition caused by an electrically energized component part, and b) confine any resulting fire within the bounds of the enclosure of the electrotechnical product in the event of ignition. Secondary aims of IEC 60695-1-10 and IEC 60695-1-11 include the minimization of any flame spread beyond the product’s enclosure and the minimization of harmful effects of fire effluents such as heat, smoke, toxicity and/or corrosivity. Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature are normally dealt with in the overall fire hazard assessment. In electrotechnical equipment, overheated metal parts can act as ignition sources. In glow-wire tests, a glowing wire is used to simulate such an ignition source. IEC 60695-2-10 describes a glow-wire test appa

Scope: This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard analysis, the flammability aspects and the flame spreading to other products are not covered by this document. This basic safety publication focusing on safety test method(s) is primarily intended for use by technical committees in the preparation of safety publications in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51. One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60695-2-11-2021 PDF

IEC 60695-2-11-2021 PDF

$50.44 $100.88