Tests for power cables with extruded insulation for rated voltages above 30 kV (Um = 36 kV) up to 150 kV (Um = 170 kV)
Introduction: The first edition of IEC 60840, published in 1988, dealt only with cables. Accessories were added to the second edition, published in February 1999, which separately covered test methods and test requirements for a) cables alone, b) cables together with accessories (a cable system). Some countries then suggested that a better discrimination be made between systems, cables and accessories, particularly for the lower voltages of the scope, for example 45 kV. This was taken into account in the third edition (2004) and has been retained subsequently, giving the type approval requirements and the range of approvals for: a) cable systems, b) cables alone, c) accessories alone. Manufacturers and users may choose the most appropriate option for type approval. The fourth edition (2011) introduced the prequalification test procedure, as a cable system inclusive of accessories, for cables with high electrical stresses at the conductor screen and/or insulation screen. Other significant changes in the fourth edition were: a) The clause numbering of this document and IEC 62067 was coordinated to achieve as much commonality as possible. b) In the case of the sample test, the lightning impulse voltage test is no longer followed by a power frequency voltage test. In this fifth edition the principle changes are as follows: a) New definitions have been added for three different cable screen designs following IEC TR 61901:2016. b) Gas immersed cable terminations for use at rated voltages above 5
Scope: This document specifies test methods and requirements for power cable systems, cables alone and accessories alone, for fixed installations and for rated voltages above 30 kV (Um = 36 kV) up to and including 150 kV (Um = 170 kV). The requirements apply to single-core cables and to individually screened three-core cables and to their accessories for usual conditions of installation and operation, but not to special cables, such as submarine cables and their accessories, for which modifications to the standard tests or the setup of special test conditions can be necessary. This document does not cover transition joints between cables with extruded insulation and paper insulated cables.
Contents:
- FOREWORD
- INTRODUCTION
- Scope