Power cables with extruded insulation and their accessories for rated voltages above 30 kV (Um = 36 kV) up to 150 kV (Um = 170 kV) – Test methods and requirements
Introduction: The first edition of IEC 60840, published in 1988, dealt only with cables. Accessories were added to the second edition, published in February 1999, which separately covered test methods and test requirements for a) cables alone, b) cables together with accessories (a cable system). Some countries then suggested that a better discrimination be made between systems, cables and accessories, particularly for the lower voltages of the scope, for example 45 kV. This was taken into account in the third edition (2004) and is has been retained in this revision, which gives subsequently, giving the type approval requirements and the range of approvals for: a) cable systems, b) cables alone, c) accessories alone. Manufacturers and users may choose the most appropriate option for type approval. At its meeting in November 2004, TC 20 decided to prepare a further major revision of IEC 60840 and concluded that this edition should incorporate the recommendations for testing HV and EHV extruded cables that were under preparation by CIGRE study committee B1 WG B1.06. This work was made available as CIGRE technical brochure No. 303, before the meeting of TC 20 in October 2006. The brochure, entitled “Revision of qualification procedures for extruded (extra) high voltage a.c. underground cables”, has therefore been considered by TC 20, and considerable parts implemented in this standard. Cables with high electrical stresses at the conductor screen and/or insulation screen are now required to un
Scope: This document specifies test methods and requirements for power cable systems, cables alone and accessories alone, for fixed installations and for rated voltages above 30 kV (Um = 36 kV) up to and including 150 kV (Um = 170 kV). The requirements apply to single-core cables and to individually screened three-core cables and to their accessories for usual conditions of installation and operation, but not to special cables, such as submarine cables and their accessories, for which modifications to the standard tests may be necessary or the setup of special test conditions may need to can be devised can be necessary. This document does not cover transition joints between cables with extruded insulation and paper insulated cables.
Contents:
- FOREWORD
- INTRODUCTION
- Scope