IEC 61300-2-24-2010 PDF

IEC 61300-2-24-2010 PDF

Fibre optic interconnecting devices and passive components-Basic test and measurement procedures-Part 2-24: Tests-Screen testing of ceramic alignment split sleeve by stress application

$50.44 $100.88 -50%
Product Code: IEC 61300-2-24
Stock In Stock
Edition: 2.0
Published: 04/2010
Number of Pages: 20
File Size: 1 file, 910 KB

Available Options

Product Description

Fibre optic interconnecting devices and passive components – Basic test and measurement procedures – Part 2-24: Tests – Screen testing of ceramic alignment split sleeve by stress application

Scope: The purpose of this part of IEC 61300 is to identify weaknesses in a ceramic alignment split sleeve which could lead to early failure of the component. General description Ceramic alignment sleeves are important components often used in the adaptor of plug- adaptor-plug optical connector sets. By using the method described, the component is subjected to a proof stress greater than would be experienced under normal service conditions. This enables weak products to be screened out. Apparatus The apparatus and arrangement necessary to perform this screening procedure are shown in Figure 1. The material needed consists of the following: a) a reference gauge made of ceramic with a sleeve-holding section, a tapered section and a stress-applying section. The diameter of each section is dependent on the dimensions of the product being screened. The length of the sleeve-holding section and the stress- applying section should be greater than the component being tested; b) plates A and B, each having a clearance hole in the centre to allow the plate to move a sample of a ceramic alignment split sleeve on the reference gauge.

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61300-2-24-2010 PDF

IEC 61300-2-24-2010 PDF

$50.44 $100.88