IEC 61439-1 (REDLINE + STANDARD)-2020 PDF

IEC 61439-1 (REDLINE + STANDARD)-2020 PDF

Low-voltage switchgear and controlgear assemblies-Part 1: General rules

$509.45 $1,018.89 -50%
Product Code: IEC 61439-1 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 05/2020
Number of Pages: 515
File Size: 1 file

Available Options

Product Description

Low-voltage switchgear and controlgear assemblies – Part 1: General rules

Introduction: The purpose of this document is to harmonize as far as practicable all rules and requirements of a general nature applicable to low-voltage switchgear and controlgear assemblies (ASSEMBLIES), in order to obtain uniformity of requirements and verification for assemblies and to avoid the need for verification in other standards. All those requirements for the various assembly standards which can be considered as general have therefore been gathered in this document together with specific subjects of wide interest and application, e.g. temperature- rise, dielectric properties, etc. For each type of low-voltage switchgear and controlgear assembly, only two main standards are necessary to determine all requirements and the corresponding methods of verification: the basic standard, (this document) referred to as “IEC 61439-1” in the specific standards, covering the various types of low-voltage switchgear and controlgear assemblies; the specific assembly standard hereinafter also referred to as the relevant assembly standard. For a general rule to apply to a specific assembly standard, it should be explicitly referred to by quoting this document followed by the relevant clause or subclause number e.g. “IEC 61439-1:2020, 9.1.3”. A specific assembly standard may not require, and hence need not call up, a general rule where it is not applicable, or it may can add requirements if the general rule is deemed inadequate in the particular case, but it may not deviate from it unless there is

Scope: NOTE 1 Throughout this standard, the term ASSEMBLY (see 3.1.1) is used for a low-voltage switchgear and controlgear assembly. This part of IEC 61439 lays down the general definitions and states the service conditions, construction requirements, technical characteristics and verification requirements for low- voltage switchgear and controlgear assemblies. This standard cannot be used alone to specify an ASSEMBLY or used for a purpose of determining conformity. ASSEMBLIES shall comply with the relevant part of the IEC 61439 series; Parts 2 onwards. NOTE Throughout this document, the term assembly(s) (see 3.1.1) is used for a low-voltage switchgear and controlgear assembly(s). For the purpose of determining assembly conformity, the requirements of the relevant part of the IEC 61439 series, Part 2 onwards, apply together with the cited requirements of this document. For assemblies not covered by Part 3 onward, Part 2 applies. This document applies to low-voltage switchgear and controlgear assemblies (ASSEMBLIES) only when required by the relevant assembly standard as follows: assemblies for which the rated voltage does not exceed 1 000 V in case of AC or 1 500 V in case of DC; assemblies designed for a nominal frequency of the incoming supply or supplies not exceeding 1 000 Hz; assemblies intended for indoor and outdoor applications; stationary or movable assemblies with or without an enclosure; assemblies intended for use in connection with the generation, transmission, distribution and conversion of electric energy, and for the control of electrical energy consuming equipment. ASSEMBLIES designed for use under special service conditions, for example in ships and in rail vehicles provided that the other relevant specific requirements are complied with; NOTE 2 Supplementary requirements for ASSEMBLIES in ships are covered by IEC 60092-302. ASSEMBLIES designed for electrical equipment of machines provided that the other relevant specific requirements are complied with. NOTE 3 Supplementary requirements for ASSEMBLIES forming part of a machine are covered by the IEC 60204 series. This standard applies to all ASSEMBLIES whether they are designed, manufactured and verif

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61439-1 (REDLINE + STANDARD)-2020 PDF

IEC 61439-1 (REDLINE + STANDARD)-2020 PDF

$509.45 $1,018.89