Surface mounting technology - Part 1: Standard method for the specification of surface mounting components (SMDs) (Commented Version)
Introduction: Specifications for electronic components have in the past been formulated for each component family. The regulations for environmental tests have been selected from IEC 60068 and other IEC and ISO publications. The intention for this procedure was that all components, once installed in a piece of equipment, had to satisfy certain criteria. The introduction and increasing use of different mounting processes on one assembly make it necessary essential to extend the existing requirements to include those arising from processing during assembly. Nevertheless, there existed no harmonized standard that prescribes the content of a component specification before the publication of this document. It is the purpose of this document to define the general requirements for component specifications derived from the assembly processes. This is done in three steps. In the first step, general requirements for component specifications and component design related to the handling and placement of the component on the substrate are given (Clause 4). In the second step, the requirements related to assembly processes are given (Clause 5). In the third step, additional requirements resulting from specific mounting methods are given (from Clause 6 to Clause 9). Additional consideration with respect to the through-hole components are crucial to mixed technology boards, i.e. boards containing through-hole components and SMDs, require additional consideration with respect to the through-hole components
Scope: This part of IEC 61760 defines requirements for component specifications of electronic components that are intended for usage in surface mounting technology. To this end, it specifies a reference set of process conditions and related test conditions to be considered when compiling component specifications. The objective of this document is to ensure that a wide variety of SMDs can be subjected to the same placement, mounting and subsequent processes (e.g. cleaning, inspection) during assembly. This document defines tests and requirements that need to be part of are included in any SMD component’s general, sectional or detail specification. In addition, this document provides component users and manufacturers with a reference set of typical process conditions used in surface mounting technology. Some of the requirements for component specifications in this document are also applicable to components with leads intended for mounting on a circuit board, including solderless interconnection technology. Cases for which this is appropriate are indicated in the relevant subclauses. NOTE Solderless interconnection technology refers to a mounting method which is not part of the surface-mounting process and the components do not undergo a soldering operation. Such components are included in this document because the mounting of components for solderless interconnection commonly occurs after the mounting of SMDs.
Contents:
- FOREWORD
- INTRODUCTION
- Scope