Superconductivity – Part 16: Electronic characteristic measurements – Power-dependent surface resistance of superconductors at microwave frequencies
Introduction: Since the discovery of high-Tc superconductors (HTS), extensive researches have been performed worldwide for electronic applications and large-scale applications. In the fields of electronics, especially in telecommunications, microwave passive devices such as filters using HTS are being developed and testing is underway on sites [1,2,3,4]1. Superconductor materials for microwave resonators, filters, antennas and delay lines have the advantage of ultra-low loss characteristics. Knowledge of this parameter is vital for the development of new materials on the supplier side and the design of superconductor microwave components on the customer side. The parameters of superconductor materials needed to design microwave components are the surface resistance Rs and the temperature dependence of the Rs. Recent advances in HTS thin films with Rs, several orders of magnitude lower than normal metals has increased the need for a reliable characterization technique to measure this property [5,6]. Among several methods to measure the Rs of superconductor materials at microwave frequencies, the dielectric resonator method [7,8,9] has been useful due to that the method enables to measure the Rs nondestructively and accurately. In particular, the sapphire resonator is an excellent tool for measuring the Rs of HTS materials [10]. In 2002, the International Electrotechnical Commission (IEC) published the dielectric resonator method as a measurement standard [11]. The test method given in this
Scope: This part of IEC 61788 involves describing the standard measurement method of power-dependent surface resistance of superconductors at microwave frequencies by the sapphire resonator method. The measuring item is the power dependence of Rs at the resonant frequency. The following is the applicable measuring range of surface resistances for this method: Frequency: f ~ 10 GHz Input microwave power: Pin < 37 dBm (5 W) The aim is to report the surface resistance data at the measured frequency and that scaled to 10 GHz using the Rs ∝ f2 relation for comparison.
Contents:
- FOREWORD
- INTRODUCTION
- Scope