IEC 61788-19-2013 PDF

IEC 61788-19-2013 PDF

Superconductivity-Part 19: Mechanical properties measurement-Room temperature tensile test of reacted Nb3Sn composite superconductors

$186.00 $371.99 -50%
Product Code: IEC 61788-19
Stock In Stock
Edition: 1.0
Published: 11/2013
Number of Pages: 90
File Size: 1 file, 1 Byte

Available Options

Product Description

Superconductivity – Part 19: Mechanical properties measurement – Room temperature tensile test of reacted Nb3Sn composite superconductors

Introduction: The Cu/Nb3Sn superconductive composite wires are multifilamentary composite materials. They are manufactured in different ways. The first method is the bronze route, where fine Nb / Nb alloy filaments are embedded in a bronze matrix, a barrier and a copper stabilizer. The second is the internal-tin method, where fine multifilaments are composed with copper matrix including Sn reservoirs, a barrier, and a copper stabilizer. The third is the powder-in-tube method, where Nb / Nb alloy tubes are filled with Sn rich powders and are embedded in a Cu stabilizing matrix. Common to all types of Nb3Sn composite wires is that the superconducting A15 phase Nb3Sn has been formed at final wire dimension by applying one or more heat treatments for several days with a temperature at the last heat treatment step of around 640 °C or above. This superconducting phase is very brittle and failure of filaments occurs – accompanied by the degradation of the superconducting properties. Commercial composite superconductors have a high current density and a small cross- sectional area. The major application of the composite superconductors is to build superconducting magnets. This can be done either by winding the superconductor on a spool and applying the heat treatment together with the spool afterwards (wind and react) or by heat treatment of the conductor before winding the magnet (react and wind). While the magnet is being manufactured, complicated stresses are applied to its windings. Therefore

Scope: This part of IEC61788 covers a test method detailing the tensile test procedures to be carried out on reacted Cu/Nb3Sn composite superconducting wires at room temperature. The object of this test is to measure the modulus of elasticity and to determine the proof strength of the composite due to yielding of the copper and the copper tin components from the stress versus strain curve. Furthermore, the elastic limit, the tensile strength, and the elongation after fracture can be determined by means of the present method, but they are treated as optional quantities because the measured quantities of the elastic limit and the elongation after fracture have been reported to be subject to significant uncertainties according to the international round robin test. The sample covered by this test procedure should have a bare round or rectangular cross- section with an area between 0,15 mm2 and 2,0 mm2 and a copper to non-copper volume ratio of 0,2 to 1,5 and should have no insulation.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-19-2013 PDF

IEC 61788-19-2013 PDF

$186.00 $371.99