Superconductivity - Part 24: Critical current measurement - Retained critical current after double bending at room temperature of Ag-sheathed Bi-2223 superconducting wires
Introduction: In 1988, a new class of high critical temperature (Tc) copper oxide superconductors, Bi-Sr-Ca-Cu-O, was discovered. After nearly three decades, (Bi,Pb)2Sr2Ca2Cu3Ox (Bi-2223) is now being utilized as a commercial high-Tc superconducting wire. Superconducting wires are often subjected to bending deformation during production and application, e.g. during wire processing, magnet construction, cable fabrication, etc. The wire is bent towards both the upper and lower directions as it passes through several pulleys. These production processes are carried out at room temperature. Critical current of the wire is likely influenced through such bending, and may be accompanied by irreversible degradation in case of large deformation. The easiest way to evaluate the influence of bending on critical current is to carry out comparative measurement with the wire in the straight form before and after bending to a specific diameter. After a wire is made into a coil or a cable, critical current is often measured under bending conditions or a more complex deformation state. In these cases, change in critical current may include both reversible and irreversible contributions depending on the amount of deformation. Irreversible degradation usually originates from a fracture in the superconducting component. In order to evaluate only irreversible contributions, measuring the retained critical current after the wire is straightened back from its deformed shape is necessary. The critical bending diam
Scope: This part of IEC 61788 describes a test method for determining the retained critical current after double bending at room temperature of short and straight Ag- and/or Ag alloy-sheathed Bi-2223 superconducting wires that have the shape of a flat or square tape containing mono- or multicores of oxides. The wires can be laminated with copper alloy, stainless steel or Ni alloy tapes. The test method is intended for use with superconductors that have a critical current less than 300 A and an n-value larger than 5. The test to determine the retained critical current is carried out without an applied magnetic field, with the test specimen immersed in a liquid nitrogen open bath.
Contents:
- FOREWORD
- INTRODUCTION
- Scope