Superconductivity – Part 25: Mechanical properties measurement – Room temperature tensile test on REBCO wires
Introduction: Several types of composite superconductors have now been commercialized. The rare-earth-based oxide superconductor (SC) with chemical formula REBa2Cu3O7 is used for practical SC wires, where the rare-earth element RE is typically Y, Dy, Gd, Nd, Ho or Sm, or a combination of two or more among them. This type of practical SC wire is usually called REBCO coated conductors. A typical architecture consists of a substrate of Ni-Cr-Mo based alloy, Ni-W alloy or stainless steel, a buffer layer consisting of a plurality of oxides, a SC layer and a protection layer of Ag. The substrate and buffer layer act as template to facilitate the well-oriented SC layer. In order to resist the large electromagnetic force, the wires are often externally reinforced by laminating thin stainless steel or Cu alloy foils. Commercial composite superconductors have a high current density and a small cross-sectional area. The major application of composite superconductors is to build electrical power devices and superconducting magnets. Complex stresses and strains are applied to the composite superconducting wires when devices are manufactured and energized. In the case of superconducting magnets, large electromagnetic forces are experienced by the windings due to the combination of high magnetic fields and high current density. It is therefore indispensable to determine the mechanical properties of the practical REBCO wires.
Scope: This part of IEC 61788 specifies the test method and procedures for testing tensile mechanical properties of REBCO superconductive composite tapes at room temperature. This test is used to measure the modulus of elasticity and 0,2 % proof strength. The values for elastic limit, fracture strength and percentage elongation after fracture serve only as a reference. This document applies to samples having a rectangular cross-section with an area of 0,12 mm2 to 6,0 mm2 (corresponding to the tapes with width of 2,0 mm to 12,0 mm and thickness of 0,06 mm to 0,5 mm).
Contents:
- FOREWORD
- INTRODUCTION
- Scope