IEC 61788-27-2025 PDF

IEC 61788-27-2025 PDF

Superconductivity-Part 27: Twist pitch measurement of practical superconducting wires-Twist pitch measurement of Nb-Ti/Cu and Nb-Sn/Cu composite superconductors

$163.93 $327.86 -50%
Product Code: IEC 61788-27
Stock In Stock
Edition: 1.0
Published: 02/2025
Number of Pages: 78
File Size: 1 file, 1 Byte

Available Options

Product Description

Superconductivity – Part 27: Twist pitch measurement of practical superconducting wires – Twist pitch measurement of Nb-Ti/Cu and Nb-Sn/Cu composite superconductors

Introduction: Twisting of multi-filamentary superconductors is an important step in the development of wires with AC losses at an acceptable level for AC applications. The necessary twist pitch depends on wire architecture, critical current density, matrix material, and external factors such as temperature, frequency and applied magnetic field. Therefore, twist pitch is a very important parameter in the design and application of composite superconducting wires, which is often inspected in the last stage of fabrication. Due to the different architectures of different composite superconductors, appropriate test methods should be adopted for specific architectures. This document specifies the untwisting method for measuring the twist pitch of Nb-Ti/Cu and Nb-Sn/Cu composite superconductors [1]1. As supplementary methods, the direct measurement method and the image processing method [1] are specified in Annex A and Annex B, respectively. ___________ 1 Numbers in square brackets refer to the Bibliography.

Scope: This part of IEC 61788 specifies a test method for the twist pitch measurement of Nb-Ti/Cu and Nb-Sn/Cu composite superconductors by an untwisting method. The test method is applicable to Nb-Ti/Cu and Nb-Sn/Cu composite superconducting wires with monolithic structures, which have either a round cross section with a diameter ranging from 0,2 mm to 2 mm or a rectangular cross section that is equivalent in area to the round cross-sectional wires. These wires possess a filament diameter ranging from 6 µm to 200 µm, a twist pitch between 5 mm and 50 mm, and a matrix of copper or copper alloy. This document uses nitric acid to remove the matrix (copper or copper alloy), so the surface of the composite superconducting wire can be plated with a material that is dissolvable by nitric acid. Though uncertainty can increase, the method can apply to Nb-Ti/Cu or Nb-Sn/Cu composite superconducting wires when the parameters of cross-sectional area, filament diameter and twist pitch are out of the limit. The test method specified in this document is expected to apply to other types of composite superconducting wires after some appropriate modifications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Uncertainty of measurement
  • 11 Test report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-27-2025 PDF

IEC 61788-27-2025 PDF

$163.93 $327.86