IEC 61788-7-2020 PDF

IEC 61788-7-2020 PDF

Superconductivity-Part 7: Electronic characteristic measurements-Surface resistance of high-temperature superconductors at microwave frequencies

$186.00 $371.99 -50%
Product Code: IEC 61788-7
Stock In Stock
Edition: 3.0
Published: 03/2020
Number of Pages: 92
File Size: 1 file, 3 Bytes

Available Options

Product Description

Superconductivity – Part 7: Electronic characteristic measurements – Surface resistance of high-temperature superconductors at microwave frequencies

Introduction: Since the discovery of some Perovskite-type Cu-containing oxides, extensive research and development (R & D) work on high-temperature superconductors (HTS) has been, and is being, done worldwide, and its application to high-field magnet machines, low-loss power transmission, electronics and many other technologies is in progress. In various fields of electronics, especially in telecommunication fields, microwave passive devices such as filters using HTS are being developed and are undergoing on-site testing [1]1 [2]. Superconductor materials for microwave resonators [3], filters [4], antennas [5] and delay lines [6] have the advantage of very low loss characteristics. The parameters of superconductor materials needed for the design of microwave low loss components are the surface resistance, (Rs) and the temperature dependence of the Rs. Knowledge of this parameter is of primary importance for the development of new materials on the supplier side and for the design of superconductor microwave components on the customer side. Rs of high quality HTS films is generally several orders of magnitude lower than that of normal metals [7] [8] [9] [10], which has increased the need for a reliable characterization technique to measure this property. Traditionally, the Rs of niobium or any other low-temperature superconducting material was measured by first fabricating an entire three-dimensional resonant cavity and then measuring its Q-value [11]. The Rs could be calculated by solving t

Scope: This part of IEC 61788 describes measurement of the surface resistance (Rs) of superconductors at microwave frequencies by the standard two-resonator method. The object of measurement is the temperature dependence of Rs at the resonant frequency. The applicable measurement range of Rs for this method is as follows: Frequency: 8 GHz < f < 30 GHz Measurement resolution: 0,01 mΩ at 10 GHz The Rs data at the measured frequency, and that scaled to 10 GHz, assuming the f 2 rule for comparison, is reported.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-7-2020 PDF

IEC 61788-7-2020 PDF

$186.00 $371.99