Electrical installations for lighting and beaconing of aerodromes – Part 1-2: Fundamental principles – Particular requirements for series circuits
Introduction: This document is a part of the IEC 61820 series that describes the minimum requirements for the lifecycle of an aeronautical ground lighting (AGL) system including design, installation, commissioning, maintenance, decommissioning and disposal. The series circuit normally operates with a constant current and a load dependent variable voltage. The protective measures for series circuits according to this document are adapted to that supply concept and the extreme long cables in the field. They are based in principle on an IT supply concept (floating and separated from ground) and the protection against direct contact to any live part at least for the primary circuit and safety extra low voltage (SELV) or protective extra low voltage (PELV) power supply feeding the light fixtures or other loads of the series circuit. In recognition of possible aviation hazards, an automatic disconnection of the AGL system in case of an electrical failure is not required in general (see details in IEC 61820-1). People involved in work on AGL electrical systems are knowledgeable of the specific risks and the safety procedures involved in the work related to the applied system design. It is strongly recommended to do a work safety risk analysis considering all local circumstances to define safe work procedures and training to the personnel. Training regarding the hazards of series circuits should be provided to non-electricians (e.g. grass cutters, snow plow operators, etc.) NOTE 1 For specificatio
Scope: This part of IEC 61820 describes requirements for AGL systems including power supplies, transformation of energy, cables, and any electrical component utilized to produce the light intended to be used as a visual aid for air and ground navigation based on IEC 61820-1, complemented with series circuit specific topics.
Contents:
- FOREWORD
- INTRODUCTION
- Scope