Mobile and fixed offshore units – Electrical installations – Part 4: Cables
Introduction: IEC 61892 forms a series of International Standards for safety in the design, selection, installation, maintenance and use of electrical equipment for the generation, transmission, storage, distribution and utilization of electrical energy for all purposes in offshore units which are used for the purpose of exploration or exploitation of petroleum resources. This part of IEC 61892 incorporates and coordinates, as far as possible, existing rules and forms a code of interpretation, where applicable, of the requirements of the International Maritime Organization (IMO), and constitutes a guide for future regulations which may be prepared and a statement of practice for offshore unit owners, designers, installers and appropriate organizations. This document is based on solutions and methods which are in current use, but it is not intended to impede the development of new or improved techniques. In this revision, voltage limitations have been removed. However, voltage limitations may be given in the referenced equipment standards. The removal of voltage limitations is considered necessary due to the interconnection of, and supply from shore to offshore units. In such cases, transmission voltages up to 132 kV AC and 150 kV DC are used and higher voltages are being planned. The IEC 61892 series aims to constitute a set of International Standards for the offshore petroleum industry, but it is not intended to prevent their use beyond petroleum installations.
Scope: This part of IEC 61892 is applicable to the selection of electrical cables intended for fixed electrical systems in mobile and fixed offshore units, including pipeline, pumping or "pigging" stations, compressor stations and single buoy moorings, used in the offshore petroleum industry for drilling, production, accommodation, processing, storage and offloading purposes. This document specifies requirements such as those concerning types of cables, voltage rating of cables, cables and wiring for interconnection of equipment, current-carrying capacities for continuous service, correction factors for different ambient temperature and for short time duty, and short-circuit withstand capacity. This document also gives information on the jet fire test for hydrocarbon (HCF) fire resistant cables. The reference to fixed electrical systems includes those subjected to vibration due to the movement of the unit, for example, cables installed on a drag chain, and not those intended for repeated flexing. This document does not cover flexible cables, for example, those used on drilling decks for top-drive, or cables for portable equipment. This document is applicable for cables with a rated voltage up to and including 18/30 kV AC and makes reference to cable standards developed by SC 18A. For higher voltages, relevant standards developed by TC 20 are applicable. This document does not apply to optical fibre cables, sub-sea and umbilical cables;, cables supplying downhole pumps, and data, telecommunication and radio frequency cables.
Contents:
- FOREWORD
- INTRODUCTION
- Scope