IEC 62005-9-2-2007 PDF

IEC 62005-9-2-2007 PDF

Reliability of fibre optic interconnecting devices and passive optical components-Part 9-2: Reliability qualification for single fibre optic connector sets-Single mode

$50.44 $100.88 -50%
Product Code: IEC 62005-9-2
Stock In Stock
Edition: 1.0
Published: 05/2007
Number of Pages: 36
File Size: 1 file, 308 Bytes

Available Options

Product Description

Reliability of fibre optic interconnecting devices and passive optical components – Part 9-2: Reliability qualification for single fibre optic connector sets – Single mode

Introduction: Both performance qualification standards and reliability qualification standards (RQS) define a set of prescribed conditions and contain a series or a set of tests and measurements (which may or may not be grouped into a specific schedule) with clearly defined conditions, severities and pass/fail criteria. The tests are intended to be run on a ‘once-off’ basis to prove the product’s ability to satisfy the performance or reliability requirements of a specific application, market sector or user group. The remaining parts of this series contain those sets of reliability criteria that have been standardized for international use. A product that has been shown to meet all the requirements of a reliability standard may be declared as complying with that reliability standard. It is recognised that component reliability qualification could be accomplished in alternative ways. The procedures in this standard are a baseline, but other qualification methods could prove to be more cost-effective. Alternative methods may be included in future revisions of this standard if they are demonstrated to be effectively equivalent to the baseline procedures. Compliance with an RQS demonstrates that a product has met its optical and mechanical performance over the duration of the applied test programs. Consistency of manufacture should be maintained using a recognized Quality Assurance program.

Scope: This part of IEC 62005 applies to fibre optic connector sets and contains the minimum test and measurement requirements and severities which a fibre optic connector set shall satisfy in order to be qualified as meeting the requirements for reliability qualification of singlemode fibre optic connectors with single fibre cylindrical ferrule PC polished as defined in the IEC 61754 series and used in controlled and uncontrolled environments (categories C and U) as defined in IEC 61753-1.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 4.10 Reference product definition
  • 4.11 Reliability standard test report
  • 20 % LTPD

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62005-9-2-2007 PDF

IEC 62005-9-2-2007 PDF

$50.44 $100.88