IEC 62047-35-2019 PDF

IEC 62047-35-2019 PDF

Semiconductor devices-Micro-electromechanical devices-Part 35: Test method of electrical characteristics under bending deformation for flexible electromechanical devices

$100.88 $201.76 -50%
Product Code: IEC 62047-35
Stock In Stock
Edition: 1.0
Published: 11/2019
Number of Pages: 46
File Size: 1 file, 2 Bytes

Available Options

Product Description

Semiconductor devices – Micro-electromechanical devices – Part 35: Test method of electrical characteristics under bending deformation for flexible electromechanical devices

Introduction: In the recent trend toward ubiquitous sensor society and the world of internet of things, demand and thus the market for softer electronic devices are quickly expanding. That is what flexible micro-electromechanical devices are for, some of which are already released into the market. Even a so-called foldable device is under development and will soon appear in the market. However, to operate trillions of such devices for the comfort and safety of human beings, the reliability of the individual devices is a critical concern. Especially in the case of flexible devices, robustness against bending deformation is an important issue which is shared among all the producers and users of such devices. In order to understand how safe a situation is, critical conditions for possible dangers should be thoroughly determined so that the potential risk can be for the first time managed. In this context, flexible devices should be folded in two at least once so that every possible critical failure actually appears. This standard procedure of testing is designed with the emphasis on such a point and with the applicability not only to already emerging flexible devices but also to so-called foldable devices which still function even when the device is folded.

Scope: This part of IEC 62047 specifies the test method of electrical characteristics under bending deformation for flexible electromechanical devices. These devices include passive micro components and/or active micro components on the flexible film or embedded in the flexible film. The desired in-plane dimensions of the device for the test method ranges typically from 1 mm to 300 mm and the thickness ranges from 10 µm to 1 mm, but these are not limiting values. The test method is so designed as to bend devices in a quasi-static manner monotonically up to the maximum possible curvature, i.e. until the device is completely folded, so that the entire degradation behaviour of the electric property under bending deformation is obtained. This document is essential to estimate the safety margin under a certain bending deformation and indispensable for reliable design of the product employing these devices.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62047-35-2019 PDF

IEC 62047-35-2019 PDF

$100.88 $201.76