IEC 62321-14-2026 PDF

IEC 62321-14-2026 PDF

Determination of certain substances in electrotechnical products - Part 14: Short-chain chlorinated paraffins (SCCPs) and medium-chain chlorinated paraffins (MCCPs) in plastics by gas chromatography-negative chemical ionization-mass spectrometry (GC-NCI-MS)

$100.88 $201.76 -50%
Product Code: IEC 62321-14
Stock In Stock
Edition: 1.0
Published: 05/2026
Number of Pages: 26
File Size: 1 file

Available Options

Product Description

Determination of certain substances in electrotechnical products - Part 14: Short-chain chlorinated paraffins (SCCPs) and medium-chain chlorinated paraffins (MCCPs) in plastics by gas chromatography-negative chemical ionization-mass spectrometry (GC-NCI-MS)

Introduction: The widespread use of electrotechnical products has drawn increased attention to their impact on the environment. In many countries this has resulted in the adoption of regulations affecting wastes, substances and energy use of electrotechnical products. The use of certain substances (e.g. lead (Pb), cadmium (Cd) and polybrominated diphenyl ethers (PBDEs)) in electrotechnical products is a source of concern in current and proposed regional legislation. The purpose of the IEC 62321 series is therefore to provide test methods that will allow the electrotechnical industry to determine the levels of certain substances of concern in electrotechnical products on a consistent global basis. This first edition of IEC 62321-14 introduces a new subject covering short-chain chlorinated paraffins (SCCPs) and medium-chain chlorinated paraffins (MCCPs).

Scope: This part of IEC 62321 specifies one technique for the determination of short-chain and medium-chain chlorinated paraffins (SCCPs: C10-C13 and MCCPs: C14-C17) in plastics of electrotechnical products. This document specifies a quantitative method for the determination of short-chain and medium- chain chlorinated paraffins in electrotechnical products by means of solvent extraction and gas chromatography-negative chemical ionization-mass spectrometry (GC-NCI-MS). This test method has been evaluated for use with ABS (acrylonitrile butadiene styrene) and PVC (polyvinyl chloride) containing individual SCCPs ranging from 369,7 mg/kg to 8 653,9 mg/kg and MCCPs ranging from 2 141,1 mg/kg to 27 329,6 mg/kg as shown in the pre- IIS 14 results in Annex C. The use of this test method for other plastics and concentration ranges has not been specifically evaluated. This document is a basic environment horizontal publication focusing on test methods and is primarily intended for use by committees in the preparation of publications within the area of environment in accordance with the principles laid down in IEC Guide 123. Wherever applicable, it is the responsibility of committees to make use of environment basic publications in the preparation of their environment group and product publications. Committees can apply this document directly to products when they do not develop a product publication in the area of environment. WARNING – Persons using this International Standard should be familiar with normal laboratory practice. This International Standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any national regulatory conditions.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 59 % chlorides, upper chromatogram standard, lower chromatogram sample
  • 55 % chlorides, upper chromatogram standard, lower chromatogram sample

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62321-14-2026 PDF

IEC 62321-14-2026 PDF

$100.88 $201.76