Dynamic modules – Generic specification
Introduction: This document applies to dynamic devices as defined in IEC TS 62538. This document contains general guidance for the IEC 62343 series related to dynamic devices and definitions which apply to dynamic devices. The dynamic module (DM), or device, has two distinguishing characteristics: dynamic and module. "Dynamic" highlights the functions of the products to include "tuning, varying, switching, configuring, and other continuous optimization," often accomplished by electronics, firmware, software or their combinations. The dynamic device usually has a certain level of intelligence to monitor or measure the situation its configuration or settings and make decisions for necessary (optimization) actions. The behaviour of dynamic modules may can be characterized by transient characteristics as the dynamic module undergoes tuning, switching, configuring, and other continuous optimization. Characterization of transient characteristics will be considered in individual dynamic module standards. "Module" defines that products covered by this document are the integration of active and passive components (either or both), through interconnecting materials or devices. The controlling electronics can be inside or outside the optical package that contains all or most of the optical components and interconnection. The product can be a small printed wiring board (PWB) or child-board with mounted optical module, or it can be a small box (e.g., housing) with optical components and electronics enc
Scope: This document applies to all commercially available optical dynamic modules and devices. It describes the products covered by the IEC 62343 series, defines terminology, fundamental considerations and basic approaches. The object of this document is to establish uniform requirements for operation, reliability and environmental properties of dynamic modules (DMs) to be implemented in the appropriate DM standard, and provide assistance to the purchaser in the selection of consistently high-quality DM products for their particular applications, as well as in the consultation of the appropriate specific DM standard(s). This document covers performance templates, performance standards, reliability qualification requirements, hardware and software interfaces and related testing methods. Since a dynamic module integrates an optical module/device, printed wiring board, and software/firmware, the standards developed in the series will mimic appropriate existing standards. On the other hand, since "dynamic module" is a relatively new product category, the dynamic module standards series will not be bound by the existing practices where requirements differ. The safety standards as related to dynamic modules are mostly optical power considerations, which is covered by IEC TC 76: Optical radiation safety and laser equipment the IEC 60825 series (see Clause 6).
Contents:
- FOREWORD
- INTRODUCTION
- Scope