Nuclear power plants – Instrumentation and control important to safety – Selection and use of industrial digital devices of limited functionality
Introduction: a) Technical background, main issues and organisation of the Standard This IEC standard specifically focuses on the selection and evaluation of pre-developed dedicated devices of limited, specific functionality and limited configurability for use in a nuclear power plant, where these devices incorporate either software or digital circuit designs specified using hardware description languages and where these devices have been produced to a recognized non-nuclear standard, but not to the SC 45A series of standards. It is intended that the Standard be used by designers of NPPs, operators of NPPs (utilities), systems evaluators and by licensors. The focus of this standard is on two aspects that are not addressed by other standards in the IEC SC 45A series: Other standards address the hardware aspects of devices containing software, or address complex devices such as PLCs containing software where that software has the potential to be much more complex1 than in the devices covered by this standard, and Other standards focus on devices to be designed specifically for nuclear applications, whereas this standard focuses on the considerations necessary to apply devices in NPPs that have not been designed for nuclear use. Designers of I&C systems for NPPs are increasingly forced to turn to such devices because of reasons such as equipment obsolescence, the small size of the nuclear market as compared to the industrial market, and the growing number of suppliers who choose to design to
Scope: 1.1 General This International Standard addresses certain devices that contain embedded software or electronically-configured digital circuits that have not been produced to other IEC Standards which apply to systems and equipment important to safety in Nuclear Power Plants, but which are candidates for use in nuclear power plants. It provides requirements for the selection and evaluation of such devices where they have dedicated2, limited, and specific functionality and limited configurability. In accordance with IEC 61513, I&C systems important to safety of classes 1, 2 and 3 may be implemented using conventional hard-wired equipment, digital technology equipment (computer based or programmed hardware) or by using a combination of both types of equipment. This International Standard provides the acceptance criteria for the selection, evaluation and use of certain digital devices that have not been developed specifically for use in these nuclear I&C systems. Such devices are very often developed to meet IEC 61508, and this standard acknowledges that compliance with IEC 61508 can be a key positive factor when qualifying non-nuclear components for nuclear sector use. Devices addressed by this Standard are dedicated devices of limited, specific functionality, that contain or may contain components driven by software or digital circuits designed using software-based tools. Examples are smart sensors, valve positioners, electrical protective devices or inverters that contain or may contain components driven by software or digital circuits designed using software-based tools. This standard does not address the software aspects of complex general-purpose devices that are addressed by other standards, such as IEC 60880 and IEC 62138 for software. This standard addresses the issues that should be considered when evaluating the suitability of these dedicated devices of limited, specific functionality for use in a nuclear power plant. The intent is to apply a graded approach to these issues, with more demanding requirements applied for higher classes. These issues include: functional suitability (does the device perform the functions required, and are these functions suit
Contents:
- FOREWORD
- INTRODUCTION
- Scope