Printed electronics – Part 202-9: Materials – Conductive ink – Printed patterns for mechanical test
Introduction: Printing processes are highly promising technologies for the fabrication of flexible electronics such as flexible displays, sensors, batteries, printed circuit boards, etc. During their lifetime, flexible printed electronics can experience various mechanical deformations in random directions such as bending, torsion, creasing, and rolling. Repeated mechanical deformations lead to significant stress and can cause the failure of flexible electronics products. Therefore, a standard test method to evaluate the mechanical reliability of flexible printed electronics is recommended. Mechanical test methods for final products such as flexible displays, sensors, and batteries are recommended in the industry. Moreover, a mechanical test for printed circuits and printed devices is recommended because the printing materials will be used and commercialized as basic components to develop the final printed electronics. To test the mechanical reliability of printed circuits and printed devices, a proper mechanical test method and a standard pattern are recommended. Several mechanical test methods for flexible printed electronics such as the bending test, rolling test, and torsion test are already proposed in IEC. These previous methods suggested mechanical test methods but they focused on measuring the device reliability of the final product such as the flexible display, sensor, and battery rather than the reliability of each component. Therefore, to test the mechanical reliability of printe
Scope: This part of IEC 62899 describes basic patterns to evaluate the electrical reliability of a conductive layer under mechanical deformation. Using the standard pattern described in this document, the comparison of the electrical reliability of a conductive layer under mechanical deformation is possible when the sample dimension is identical.
Contents:
- FOREWORD
- INTRODUCTION
- Scope