Radiation protection instrumentation – Semi-empirical method for performance evaluation of detection and radionuclide identification – Part 1: Performance evaluation of the instruments, featuring radionuclide identification in static mode
Introduction: There are known challenges associated with the application of traditional methods1 for the performance evaluation of instruments used for the detection and identification of radionuclides. These challenges mainly originate from test logistics and the resources required for qualification type pass/fail tests. As an alternative approach, a semi-empirical performance evaluation method has been developed [1]2. The concept of this technique, also known as injection study, is based on computerized interpretation of detection or identification reports, obtained by injection of processed data into instrument–specific replay software for detection or radionuclide identification. The method does not prohibit the use of synthetic data if experimental data is not available. While remaining reasonably accurate, semi-empirical methods do not require significant resources for performance evaluation. In some applications, where full scope performance testing is not feasible or practical, the use of semi-empirical methods can provide reasonable confidence in the instrument performance. By no means are semi-empirical methods meant to fully replace traditional tests, but rather to complement them. It is envisioned that this standard will comprise three parts. Part 1 of the standard is specific to the performance evaluation of radionuclide identification in static mode, i.e. when measurement geometry does not change. Future parts of the standard will address detection and radionuclide identifica
Scope: This part of IEC 62957 specifies requirements for data preparation and data injection when using the semi-empirical method for performance evaluation of detection and radionuclide identification. This document recommends approaches for results interpretation and consolidation and establishes a method to share data and analysis results. This part 1 of the standard is specific to the performance evaluation of radionuclide identification in static mode, i.e. when measurement geometry does not change (e.g. radionuclide identification devices in start-stop mode).
Contents:
- FOREWORD
- INTRODUCTION
- Scope