IEC 63241-1-2023 PDF

IEC 63241-1-2023 PDF

Electric motor-operated tools-Dust measurement procedure-Part 1: General requirements

$50.44 $100.88 -50%
Product Code: IEC 63241-1
Stock In Stock
Edition: 1.0
Published: 07/2023
Number of Pages: 34
File Size: 1 file, 906 Bytes

Available Options

Product Description

Electric motor-operated tools – Dust measurement procedure – Part 1: General requirements

Introduction: Inhalable dust emitted by electric motor-operated tools can present a hazard to the operator and other exposed persons. Therefore, this document specifies a procedure to measure the dust concentration produced by an electric power tool under standardized conditions representing typical applications. However, the dust concentration during actual use of the power tool can differ from the dust concentration measured in accordance with this document depending on the ways in which the tool is used. The results of dust measurements can be used for a declaration of the dust emission; for comparing the dust emission from tools of the same type; or in a preliminary assessment of dust exposure at a workplace. For all purposes, it is important to specify measurement procedures with known accuracy so that the results of measurements taken by different laboratories can be compared. The measurements of dust concentration are made in accordance with EN 1093-9:1998 and EN 1093-9:1998/A1:2008 for the test room.

Scope: This document specifies general requirements for the dust measurement of electric motor- operated tools supplied from mains or from batteries. This document applies to those tools with and without a dust extraction unit where dust such as mineral dust containing silica or wood dust is expected.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 63241-1-2023 PDF

IEC 63241-1-2023 PDF

$50.44 $100.88