Test methods for electrical and magnetic properties of magnetic powder cores
Introduction: Magnetic powder cores have the characteristics of low relative permeability, high saturated flux density and low loss. Therefore, compared with ungapped ferrite, the equivalent impedance of a sample of magnetic powder core is much smaller, and the magnetizing current is very large, so the required excitation source will have both high frequency and high-power capacity, which is difficult to obtain in practice. Moreover, the impedance angle of a magnetic powder core under test is very close to 90°, and this results in great difficulties to obtain accurate measurements of power loss. The IEC 62044 series provides measuring methods of magnetic properties at low and high excitation levels for magnetic cores made of magnetic oxides or metallic powders. However, the methods introduced in the IEC 62044 series cannot fully meet the measurement requirements for magnetic properties of magnetic powder cores. It is therefore useful to have a standard for suitable measuring methods for the magnetic properties of magnetic powder cores. New test methods with pulse wave excitation and DC power method that account for the characteristics of magnetic power cores are introduced in this document, in addition to some modifications for the traditional test methods. Also, an air core inductor with single winding or dual windings is introduced in the document to verify or calibrate the accuracy of test methods for magnetic properties of magnetic powder cores, because of the linear properties of an a
Scope: This document provides the test methods for the electrical and magnetic properties of magnetic powder cores used for inductive components in electronics equipment, switch-mode power supplies and power conversion equipment, and introduces measuring principles, scope of application and matters of importance for each method. The parameters used to characterize the magnetic powder cores include: inductance factor, effective permeability, complex relative permeability, temperature coefficient of permeability, frequency coefficient of permeability, DC bias characteristic, power loss, and quality factor. This document is the basis for determining the characteristic parameters of magnetic powder cores.
Contents:
- FOREWORD
- INTRODUCTION
- Scope