IEC 63474-2026 PDF

IEC 63474-2026 PDF

Electrical and electronic household and office equipment - Measurement of networked standby power of edge equipment

$163.93 $327.86 -50%
Product Code: IEC 63474
Stock In Stock
Edition: 2.0
Published: 06/2026
Number of Pages: 44
File Size: 1 file, 1000 KB

Available Options

Product Description

Electrical and electronic household and office equipment - Measurement of networked standby power of edge equipment

Introduction: The methods specified in this document are intended to define requirements for the measurement of power used by equipment having one or more wired or wireless network port(s) in those modes that are able to resume a function by way of a remotely initiated trigger or reactivation trigger from a network connection (networked standby mode). For the measurement of power used in non-active mode other than networked standby mode,, reference is made to IEC 62301 [1]. This document also provides a method to test power management and to test whether it is possible to deactivate wireless network connection(s). IEC 63474:2023 [2] (ED1) was based on EN 50643:2018 [3]. It was submitted to the National Committees for voting under the Fast Track Procedure.

Scope: This document specifies methods of measurement of electrical power in networked standby mode and the reporting of the results for edge equipment. The measurement of power and energy use in non-active mode, other than networked standby mode, is covered by IEC 62301 [1], including the input voltage range. This document applies to edge equipment that is powered by: low voltage mains AC power (LV ≤ 1 000 V AC), or an external power supply that provides low voltage (LV ≤ 1 000 V) or extra low voltage (ELV ≤ 50 V) AC or DC power, or a separate source of extra low voltage DC power (ELV ≤ 50 V DC), or an internal main battery. Conditions that are outside the scope of this document are as follows: active modes (primary function), other non-active modes (which are either covered by IEC 62301 [1] or by specific product group standards), conditions where main batteries are being charged other than in maintenance mode, disconnected condition of the equipment. This document applies to the following product groups where a networked standby mode is present: edge equipment with a network reactivation function, such as household appliances, information technology equipment, audio, video and multimedia systems and equipment, digital radio receivers with an emergency warning function, gas burning equipment with electrical components. NOTE 1 The measurements of power, energy use and performance of products during their intended use (when performing their primary functions) are generally specified in product standards and are not covered by this document. NOTE 2 Networked standby mode for lighting equipment and the measurement of power is specified in IEC 63103 [4]. NOTE 3 Interconnecting equipment (equipment that provides network infrastructure and function) is outside the scope of this document. Measurement of electrical power in networked standby mode for interconnecting equipment is the subject of ETSI standard EN 303 423 [5]. This document also provides a method to test power management and to test whether it is possible to deactivate wireless network connection(s). NOTE 4 Edge equipment can also include auxiliary batteries. This group EE publication is primarily intended to be

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 63474-2026 PDF

IEC 63474-2026 PDF

$163.93 $327.86