IEC CISPR TR 30-3-2026 PDF

IEC CISPR TR 30-3-2026 PDF

Test method on electromagnetic emissions - Part 3: Electronic control gear for LED light sources - Built-in control gear

$100.88 $201.76 -50%
Product Code: IEC CISPR TR 30-3
Stock In Stock
Edition: 1.0
Published: 01/2026
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Test method on electromagnetic emissions - Part 3: Electronic control gear for LED light sources - Built-in control gear

Introduction: Requirements and test methods to limit radio-frequency disturbances from lighting equipment are standardized in CISPR 15:2018 and CISPR 15:2018/AMD1:2024. They are restricted to those kinds of lighting equipment which are considered as finished products and intended to be placed on the market for the end user, viz. luminaires, self-ballasted lamps and modules1 such as independent control gear and LED control gears. No emission requirements apply to components or modules intended to be built into luminaires. Electronic control gear can be built into a number of different types of luminaires: not only in luminaires of different manufacturers but also in different types of luminaires of a given manufacturer. Each of those luminaires including the same electronic control gear can be tested separately, although disturbance data of a certain luminaire can also very well be predicted from a test using a reference luminaire equipped with the same electronic control gear and similar light sources. The CISPR TR 30 series [1]2 are technical reports in which reference luminaires are given for testing electronic control gears for specific light source technologies3. Each part of CISPR 30 series is independent and describes the disturbance measurement test set-up for electronic control gear used together with a special light source family (applying a different technology, topology or form factor). The formatting into separately published parts provides for ease of future amendments and rev

Scope: This document details the construction and parameters of a reference luminaire, a measurement procedure and conditions for assessment of the radio disturbance characteristics of electronic control gears (ECG) for LED light sources applied inside. This document is limited to ECGs (also called “control gears”) as well as end-user replaceable ECGs with the following characteristics or applications: applied in luminaires with safety protection class I; NOTE This means that the mains interface of the ECG itself can have either a protective earth (PE) or a functional earth (FE) terminal. For details, see 4.6 and Table 2. linear form factor, i.e. fits within the space provision defined in Figure A.1 a). ECGs with a rated output power less than 360 W. Excluded from the scope of this document are: ECGs for applications that are excluded in CISPR 15:2018 and CISPR 15:2018/AMD1:2024, and control gear with only L, N input terminals (without PE terminal).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC CISPR TR 30-3-2026 PDF

IEC CISPR TR 30-3-2026 PDF

$100.88 $201.76