IEC GUIDE 103-1980 PDF

IEC GUIDE 103-1980 PDF

Guide on Dimensional Co-Ordination

$100.88 $201.76 -50%
Product Code: IEC GUIDE 103
Stock In Stock
Edition: 1.0
Published: 1980
Number of Pages: 48
File Size: 1 file, 1 Byte

Available Options

Product Description

Guide on Dimensional Co-Ordination

Introduction: Various Technical Committees meet problems of dimensional interfaces either between products within their own scope, or with products of other Committees. If such problems are solved individually in each case, the variety of solutions aggravates such interface problems. Therefore appropriate steps should be taken. The purpose of the present guide is to recommend two systems for use by Technical Commit- tees. Appendix A gives a more detailed analysis of these two systems. 1. Scope The aim of the guide is to define recommended systems of dimensional sizes applicable, in the electrotechnical field, to components, devices and equipment in order to ensure the dimensional interface, bearing in mind at the same time the need to control varieties of sizes. 2. Object In order to yield the maximum technical and economic advantages, the dimensional sys- tems in this guide have been evolved to permit the following: 1) Arrangement of products with a minimum loss of room area and space where the latter are pre-set. Dimensional interchangeability of products, e.g.: overall dimensions; mounting dimensions (fixing holes, cut-outs, etc.). Replacement of a product by several products of smaller dimensions having the same total area or space requirements, or vice versa. 4) Dimensional compatibility and determination of interface dimensions of products which are combined with other products, e.g. instruments, racks, panels and cabinets, etc.

Contents:

  • INTRODUCTION
  • 3.1 System I
  • 3.2 System II

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC GUIDE 103-1980 PDF

IEC GUIDE 103-1980 PDF

$100.88 $201.76