Application of measurement uncertainty to conformity assessment activities in the electrotechnical sector
Introduction: This document has been prepared by the IECEE Committee of Testing Laboratories (CTL) to provide guidance on the practical application of the measurement uncertainty requirements of ISO/IEC 17025:2017 to the electrical safety testing conducted within the electrotechnical sector. The aim of the CTL is, among other tasks, to define a common understanding of the test methodology with regard to the IEC standards as well as to ensure and continually improve the repeatability and reproducibility of test results among the member laboratories. The practical approach to measurement uncertainty outlined in this document has been adopted for use in the IECEE Schemes, and is also extensively used around the world by testing laboratories engaged in testing electrical products to national safety standards. ISO/IEC 17025 was written as a general use document, for all industries. Measurement uncertainty principles are applied to laboratory measurements and presentation of results to provide a degree of assurance that decisions made about conformance of the products tested, in accordance with the relevant requirements, are valid. Procedures and techniques for measurement uncertainty calculations are well established. This document is written to provide more specific guidance on the application of measurement uncertainty principles and applying the decision rule to conformance statements when reporting test results. This document is of particular interest to IEC technical committees, which can
Scope: This document presents a practical approach to the application of measurement uncertainty to electrical safety testing conducted within the electrotechnical sector. It is specifically conceived for use in IECEE Schemes as well as by testing laboratories engaged in testing electrical products to national safety standards. It describes the application of measurement uncertainty principles. This document provides guidance on making measurement uncertainty calculations and gives some examples relating to measurement uncertainty calculations for product conformity assessment testing. NOTE The IEC Standardization Management Board (SMB) has decided that Guides such as this one can have mandatory requirements which shall be followed by all IEC committees developing technical work that falls within the scope of the Guide, as well as guidance which may or may not be followed. The mandatory requirements in this Guide are identified by the use of "shall". Statements that are only for guidance are identified by using the verb "should". (See ISO/IEC Directives, IEC Supplement:2021, A.1.1.)
Contents:
- FOREWORD
- INTRODUCTION
- Scope