IEC/IEEE 61886-2-2025 PDF

IEC/IEEE 61886-2-2025 PDF

Subsea equipment - Part 2: Power transformers

$206.18 $412.35 -50%
Product Code: IEC/IEEE 61886-2
Stock In Stock
Edition: 1.0
Published: 08/2025
Number of Pages: 57
File Size: 1 file

Available Options

Product Description

Subsea equipment - Part 2: Power transformers

Introduction: Use of electrical power on the seabed is increasing. Both within the oil and gas and renewable industries, there is an increasing use of electrical power equipment on the seabed. Subsea processing activities like compression and pumping require an increasingly higher amount of electrical power. Power generation, whether onshore or offshore, requires development of equipment both for subsea transmission and distribution. This document includes requirements related to equipment installed below the sea surface. The objective of this document is to substitute project/client specific specifications. Use of this document will avoid increased costs and schedule impact (for type testing) and reduce risk for failure. By standardizing tests and implementing continuous improvement on fewer products, this risk will be reduced in the long term. The SEPS JIP (Subsea Electrical Power Standardization Joint Industry Project) was established in 2010 by seven oil and gas companies, with the aim to develop common operator standards for subsea electrical power equipment and systems and support further development of these into internationally recognized standards. This document proposal is developed by SEPS. The aim for the SEPS JIP is to develop IEC/IEEE dual logo standards; hence both IEC and relevant IEEE standards are referenced where applicable. Relevant equipment manufacturers have contributed with review and comments to the document. The lack of accessibility (for repair/replacement) defin

Scope: This part of IEC/IEEE 61886 is applicable to three-phase and single-phase liquid immersed subsea power transformers (including auto-transformers) with at least one winding with rated voltages in the range 3,6 ≤ Um ≤ 245 kV and with rated power in the range 50 kVA to 300 MVA. The intention is to specify additional requirements that are not covered by the IEC 60076 series and IEEE Std C57.12TM series. It is the intention of this document that subsea power transformers be designed and tested either in accordance with the IEC 60076 series (IEC profile) or with the IEEE C57.12 series (IEEE profile). For subsea transformers where no winding has a rated voltage above or equal to 3,6 kV, this document can be applicable, either as a whole or in part. The mechanical design principles are also applicable for liquid-immersed reactors. Where the terms "subsea transformer" or "transformer" are used, this means "transformer assembly". Where required, it is stated whether transformer accessories like penetrators and connectors are included or not.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC/IEEE 61886-2-2025 PDF

IEC/IEEE 61886-2-2025 PDF

$206.18 $412.35