IEC/IEEE 62704-4-2020 PDF

IEC/IEEE 62704-4-2020 PDF

Determining the peak spatial-average specific absorption rate (SAR) in the human body from wireless communication devices, 30 MHz to 6 GHz-Part 4: General requirements for using the finite element method for SAR calculations

$186.00 $371.99 -50%
Product Code: IEC/IEEE 62704-4
Stock In Stock
Edition: 1.0
Published: 10/2020
Number of Pages: 104
File Size: 1 file, 2 Bytes

Available Options

Product Description

Determining the peak spatial-average specific absorption rate (SAR) in the human body from wireless communication devices, 30 MHz to 6 GHz – Part 4: General requirements for using the finite element method for SAR calculations

Introduction: Finite element methods have reached a level of maturity that allows their application in specific absorption rate (SAR) assessments of professional-use and consumer-use wireless communication devices. In the recent past, SAR compliance assessments for small transmitters were performed almost exclusively using measurements. Some wireless communication devices are used in situations where experimental SAR assessment is extremely complex or not possible at all. National regulatory bodies (e.g. US Federal Communications Commission) encourage the development of consensus standards and encouraged the establishment of the ICES Technical Committee 34 Subcommittee 2. The benefits to the users and the regulators include standardized and accepted protocols, verification and validation techniques, benchmark data, reporting format and means for estimating the overall assessment uncertainty in order to produce valid, repeatable, and reproducible data. The purpose of this document is to specify numerical techniques and models to determine peak spatial-average specific absorption rates (SAR). SAR will be determined by applying finite element method simulations of the electromagnetic field conditions produced by wireless communication devices in models of the human anatomy. Intended users of this document are (but are not limited to) wireless communication device manufacturers, service providers for wireless communication that are required to certify that their products comply with the applic

Scope: This part of IEC/IEEE 62704 describes the concepts, techniques, and limitations of the finite element method (FEM) and specifies models and procedures for verification, validation and uncertainty assessment for the FEM when used for determining the peak spatial-average specific absorption rate (psSAR) in phantoms or anatomical models. It recommends and provides guidance on the modelling of wireless communication devices, and provides benchmark data for simulating the SAR in such phantoms or models. This document does not recommend specific SAR limits because these are found elsewhere (e.g. in IEEE Std C95.1 [1]1 or in the guidelines published by the International Commission on Non-Ionizing Radiation Protection (ICNIRP) [2]).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC/IEEE 62704-4-2020 PDF

IEC/IEEE 62704-4-2020 PDF

$186.00 $371.99