IEC TR 60877-1999 PDF

IEC TR 60877-1999 PDF

Procedures for ensuring the cleanliness of industrial-process measurement and control equipment in oxygen service

$50.44 $100.88 -50%
Product Code: IEC TR 60877
Stock In Stock
Edition: 2.0
Published: 01/1999
Number of Pages: 38
File Size: 1 file, 136 Bytes

Available Options

Product Description

Procedures for ensuring the cleanliness of industrial-process measurement and control equipment in oxygen service

Scope: This report outlines the procedures for cleaning industrial-process measurement and control equipment to be used for oxygen service, verifying this cleanliness and ensuring that the cleanliness of the equipment will be maintained up to the stage where the equipment is installed. This report does not apply to measurement and control equipment for welding, which is covered by ISO 5171. Oxygen service is defined as equipment or part thereof being in contact with oxygen-rich gas mixtures and other oxydizing gases (e.g. laughing gas). Greases, oils, thread lubricants, dirt, water, filings, paints, varnishes, scales, powder, etc., shall be removed because many of these materials, in particular oils and hydrocarbon greases, can react violently in the presence of oxygen and initiate fires or explosions. This report consequently covers the cleanliness procedures for the preparation, assembling, inspection, protection during transportation, storage and handling and installation of equipment, accessories or replacement parts intended for oxygen service. NOTE – Many factors can influence the reaction in the presence of oxygen. Those may be: a higher oxygen pressure; a higher temperature; the fact that oxygen flows, or is only present as a static pressure within equipment or part thereof. Reference document ISO 5171:1995, Pressure gauges used in welding, cutting and allied processes Procedures In preparing, cleaning and assembling any equipment, accessory or part for oxygen service, the following procedures shall be explicitly observed. 3.1 Orders for equipment for oxygen service Each order shall specify that the equipment and/or accessories are to be cleaned, prepared, marked and packed for use in oxygen service. Any order for replacement parts issued separately from the orders for equipment and/or accessories shall also state clearly that the parts so ordered are to be cleaned, prepared, marked, and packed for use in oxygen service.

Contents:

  • FOREWORD
  • Scope
  • 3.10 Warning
  • 3.11 Packaging for protection during transportation, storage, handling and for
  • 3.12 Installation

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 60877-1999 PDF

IEC TR 60877-1999 PDF

$50.44 $100.88