Fibre optic communication system design guides Part 2: Multimode and single-mode Gbit/s applications Gigabit ethernet model
Introduction: The enterprise networking environment has changed significantly in recent years and the available bandwidth to the desktop has greatly increased. This is due to the shift to switch- based networks from hub-based networks that allow the desktop to have full-duplex access to the available link bandwidth. Added to this is the relatively recent increase in the available link bandwidth to the desktop from 10 Mb/s to 100 Mb/s. One of the drivers for the growth in enterprise bandwidth is the increased use of applications that send large amounts of data over private intranets and the internet. Network traffic is no longer limited to just messages or file transfers; now data streams, such as audio and video, are becoming common, as well as messages with large embedded files. The growth of corporate intranets and the internet has also made network traffic patterns very unpredictable; large files can be accessed from distant places. Within private intranets, there is a growing trend towards using centralized servers. By their very nature, these servers need very high bandwidth connectivity in order to operate effectively. Due to all these drivers, there is need to increase the bandwidth of enterprise backbone links so that the networks can support the increased demands of the users and prevent congestion. Due to this demand, IEEE 802.3 (ethernet) have developed the next generation standard in the ethernet hierarchy - gigabit ethernet. In the development of gigabit ethernet, it was consi
Scope: This part of IEC 61282 describes a model developed as a tool to assist the physical layer committee of the gigabit ethernet (IEEE 802.3z) standard to understand potential trade-offs between the various link penalties associated with laser-based backbone links. The purpose of this technical report is to document the model as used by gigabit ethernet and to identify how it was used to develop the standard specifications. This technical report presents the theoretical model. Experimental verification is also presented for links operating at valid gigabit ethernet wavelengths of 780 nm, 850 nm and 1 300 nm. The technical report is organized as follows. In Clause 2, a simple theoretical prediction of laser-driven links is presented. Clause 3 contains the description of the experimental measurements and the experimental verification of the theoretical predictions. Finally, Clause 4 contains some example calculations and discussion of the results and use of the model. Theoretical model The link model is based on a power budget calculation. Power penalties, sometimes referred to as ac penalties, are allocated for link impairments such as noise and dispersion. Power loss is also included to account for connectors and fibre attenuation. The power penalties and losses are added linearly in decibels to determine the total link penalty as a function of length. In the model, it is assumed that the laser and multimode fibre impulse responses are Gaussian [2]. However, it is assumed that the optical receiver is non-equalized and has a raised cosine response. Additionally, the case where the receiver has an exponential impulse response is stated [2]. The gigabit ethernet standard uses bandwidth and rise time specifications rather than RMS pulse width. Therefore, the model includes expressions that convert the RMS impulse width of the laser, fibre and optical receiver to rise times fall times and bandwidths. These calculated rise times, fall times and bandwidths are used to determine the fibre and composite channel exit response and the ISI penalty of the optical communications link. It is assumed that rise times and fall times are equal and only the rise time is referred to thro
Contents:
- FOREWORD
- INTRODUCTION
- Scope