IEC TR 61282-8-2006 PDF

IEC TR 61282-8-2006 PDF

Fibre optic communication system design guides-Part 8: Calculating dispersion penalty from measured time-resolved chirp data

$72.51 $145.02 -50%
Product Code: IEC TR 61282-8
Stock In Stock
Edition: 1.0
Published: 11/2006
Number of Pages: 26
File Size: 1 file, 475 Bytes

Available Options

Product Description

Fibre optic communication system design guides – Part 8: Calculating dispersion penalty from measured time-resolved chirp data

Introduction: Dispersion penalty is a commonly used parameter of laser transmitters and is usually included as a specification for transmitters designed for 2,5 Gb/s and higher data rates. The value of the dispersion penalty is a function of the interaction of laser chirp, spectral width and fibre dispersion and will depend on the particular type of fibre. Because the type and length of the fibre specified for a particular transmitter is fixed, the dispersion penalty is determined by the temporal characteristics of the transmitter chirp, which include the spectral characteristics of the laser. As developers and manufacturers of laser transmitters are attempting to go to higher rates and longer distances, they are finding that chirp is limiting their ability to achieve a required dispersion penalty. Direct measurement of dispersion penalty requires two BER measurements over a reference receiver input range that yields BER values typically from 10–4 to 10–12. This is typically a long measurement. Measuring time-resolved chirp (TRC) and calculating dispersion penalty can be a considerably shorter measurement. This technical report describes the procedure for calculating dispersion penalty from TRC data.

Scope: This part of IEC 61282 provides definitions of dispersion penalty and other related penalties. It describes the direct measurement of these penalties using a BER test set and the calculation of the penalties from time-resolved chirp (TRC) data. Annex A provides the theory for power penalty calculations. The calculations are valid for all types of single longitudinal mode (SLM) laser transmitters intended for use in telecommunications applications at data rates of 2,5 Gbit/s and higher with NRZ modulation format. These include but are not limited to directly modulated DFB lasers, DFB lasers with integrated electro-absorption modulators, and DFB lasers with external Mach- Zehnder modulators. This technique is not suitable for multiple longitudinal mode (MLM) lasers or LEDs. Chromatic dispersion induced power penalty values in this technical report are characteristics of the transmitter, which is considered to be the device-under-test (DUT). Other power penalty sources, such as nonlinear effects and amplifier noise are not covered by this document. Since dispersion penalty for a transmission link depends on the transmitter, receiver and fibre, the dispersion penalty parameter for a transmitter is based on a specified fibre dispersion and receiver characteristic, which should be reported with the test results.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 61282-8-2006 PDF

IEC TR 61282-8-2006 PDF

$72.51 $145.02