IEC TR 62518-2009 PDF

IEC TR 62518-2009 PDF

Rare earth sintered magnets-Stability of the magnetic properties at elevated temperatures

$132.41 $264.81 -50%
Product Code: IEC TR 62518
Stock In Stock
Edition: 1.0
Published: 03/2009
Number of Pages: 32
File Size: 1 file, 1 Byte

Available Options

Product Description

Rare earth sintered magnets – Stability of the magnetic properties at elevated temperatures

Introduction: SmCo5 was the first sintered rare earth magnet to be developed (1967) [1] 1, followed by Sm2Co17 [2, 3, 4] and Nd-Fe-B [5]. These magnets are used in a wide variety of applications. Recently, these magnets have been used in higher temperature applications such as in heavy duty permanent magnet motors. For these high temperature applications, the temperature stability of the permanent magnet has to be considered along with the design of the magnetic circuit. This is particularly relevant for the relatively inexpensive Nd-Fe-B magnetic material which has a comparatively low Curie temperature. The temperature stability of the rare earth sintered magnets has a critical influence on the reliability of high temperature motors and this will, in turn, contribute to energy savings in the future. Therefore, the subject of this technical report will be of considerable interest to the manufacturers of this type of motor and to the developers of permanent magnet materials. ————————— 1 The figures in square brackets refer to the Bibliography.

Scope: The scope of this technical report is to describe the temperature behaviour of rare earth sintered magnets in detail for use in designing magnetic circuits exposed to elevated temperatures. The temperature behaviour of SmCo5, Sm2Co17 and Nd-Fe-B sintered magnets is described. The various changes of open circuit flux which can occur due to temperature are discussed in Clause 4. The long term stability of the magnets is discussed in Clause 5. The experimental procedures are described in Clause 6. Results of the measurements of the flux loss occurring at the ambient temperature after heating isothermally at 50 °C, 75 °C, 100 °C, 125 °C, 150 °C and 200 °C for up to 1000 h are given in Clause 7. The effect of length to diameter ratio (L/D) of the magnet samples and the influence of HcJ on the flux loss were also studied. The results are discussed in Clause 8. The data in this technical report was provided by the Institute of Electrical Engineers of Japan (IEEJ) and its subcommittees. This data has been gathered from the members of these sub- committees. The temperature stability correlated with the complex corrosion behaviour and the spin re- orientation phenomena at cryogenic temperatures will not be given in this technical report.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62518-2009 PDF

IEC TR 62518-2009 PDF

$132.41 $264.81