Fibre optic interconnecting devices and passive components – Part 03-01: Reliability – Design of an acceptance test for fibre pistoning failure of connectors during temperature and humidity cycling: demarcation analysis
Introduction: Fibre optic connectors rely on accurate positioning of the fibre with respect to an optical interface to achieve and maintain acceptable performance. Degradation of performance due to fibre motion (fibre pistoning) is a well known failure mode. It is activated by temperature and humidity exposure, especially cyclic. Clause 3 provides background on the pistoning failure mode. An acceptance test is an accelerated test designed to detect degradation or failure modes if they would occur during life, and to show no change if no degradation or failure modes will occur. A perfect acceptance test is impossible [1] 1 because (a) there can always be non- accelerable failure modes and (b) some failures may occur under acceleration that may not occur in service. However, a well-designed acceptance test provides for a supplier a reasonable check of the space of accelerable modes and is of great value in testing for reliability. Demarcation mapping provides a method of viewing possible chemical and physical processes that can occur during a given stress exposure over a given time [1-4] and allows for selection of accelerating test conditions that will produce potential degradation or failure mechanisms during service. Clause 2 provides an overview of the demarcation approach and its application to developing acceptance tests. Clause 3 provides a discussion of plausible physical processes accompanying degradation and fibre pistoning, based on an assumed service environment. It includes some
Scope: This part of IEC 62627 gives an example of the design of an acceptance test for ferrule style connectors when the dominant failure mode is fibre pistoning. The example applies to connectors which use epoxies or other adhesive polymers to bond the fibre into a ferrule. It combines existing evidence, mechanistic hypotheses and the demarcation approximation to develop an accelerated environmental exposure sequence that can be used on a pass-only basis to help ensure reliable service. This technical report was developed to serve only as an example of how accelerated acceptance tests can be designed. It is not intended as a normative standard for any specific application. Optical fibre connectors and the pistoning failure mode The most commonly used fibre optic connector designs are based on butt-joint fibre alignment. The fibre is generally adhesively-bonded inside a tightly toleranced ferrule capillary with a thermally cured epoxy. The ferrule is precision polished to ensure accurate positioning of the fibre endface for acceptable optical performance. Significant fibre motion during temperature- humidity exposure, especially cycling, will degrade the performance, causing both insertion loss and reflectance to increase and become unstable. The stresses that drive fibre motion come from three sources: (i) residual stress from the connector termination process, (ii) externally applied contact stress from a mating ferrule, or (iii) and stress from differential thermal expansion of materials in the connector assembly. Mechanisms within the adhesive which allow the motion to take place include creep, adhesive failure and cohesive failure. Demarcation map theory for thermally activated processes 3.1 Concept of demarcation energy The demarcation approximation is derived from consideration of material systems where a macroscopically observable degradation process is driven by a set of parallel thermally activated (Arrhenius) processes. Assuming each process to consist of a single step, the rate for each local process has the form: − exp (1) where is a premultiplier, is Boltzmann’s constant, is absolute temperature, and is the activation energy (in the following, all activa
Contents:
- FOREWORD
- INTRODUCTION
- Scope